No! You can go move the controller wherever you want. There are no steps!Wait, you can go half steps? I thought the controller only does full steps as in 6, 7, 8 and so on
I found the AVB gets even if I pack a full bowl tightly. But it needs at least two hits to get brown abv (I didn't go higher than 9 on the dial).I really like the glass bowl for water use, but I do think the stock bowl provides more even AVB.
thanks for the reply! I use that method as well and it works great, but I like the handling & cleaning more on the glass bowl.take herbchamber from stem and put it on glassbowl... if I remember correct the herbchamber with o-ring fits on 14mm or 18mm female joint.... so you should not need the glassbowl
I use it with the native mouthpiece all day, but I do use it on glass in the evening. It's great on its own although, for my device, I keep it below 5. That's both for comfort and the effects I want for daytime. I think you will be completely happy if you never use it with a piece.Anyone using it strictly without glass? Never been much of a bong guy and down own any, not sure if I feel like investing into that shortly before moving either.
That one is looking nice! I'm wondering if an 18-->14mm adapter exists in a non frosted version? I like to see my herbs If someone knows a place where to get them please let me know.
No. The herbs are still in the same distance. The herb chamber still gets filled up the regular way. The bowl just doesn't stop at the end of the chamber but gets deeper by the depth of the basket screen
It's just a friction fit. I just pinch the chamber with my fingers and turn the MP. If it is still hot it may have expanded a bit.I feel a little dumb for asking this, but can someone tell me how to disassemble the chamber from the mouthpiece? I am trying to remove the cooling pad to try it without (and also gonna need to disassemble at some point to clean) but it seems stuck and I only used it a few times. I tried to get it out for 10 minutes
other than that my first impressions are pretty good, but i need some more time
I dont know what I did to this chamber but I cannot get it out, must have pressed it in way too much or something, it doesnt move 1 inchIt's just a friction fit. I just pinch the chamber with my fingers and turn the MP. If it is still hot it may have expanded a bit.
You could try using some flat pliers to gently hold the chamber. I would just keep at it with your hands if it were me though.
Could be. I have had a tight fit before. But wiggling and turning it gently brought it loose. I will be curious to see what was holding it in place once you get it out.I dont know what I did to this chamber but I cannot get it out, must have pressed it in way too much or something