Man,
@P.A.M. Your vindictive posts really bum me out. Why not just try to be helpful instead of lashing out
being helpful is what i tell
@minh533 i would work hard on doing in my last post . here’s the result . but before , let me suggest ,
perhaps you should ask your question to Vapwood why he isn’t being more helpful and sharing the file himself instead of the answer given to us.
vindictive posts ? seems more every time i post facts ,
@Bravesst seems to try and discredit what i’ve said ... i usually cross the T’s and dot the I ‘s , donT i?
as
@cpk points out , what’s wrong with using the board to the max? it indeed was a selling point at a time and could still be. your cheaper board idea if going simple as value too .
now ,in doing my part to be helpful as to
@minh533, please follow steps below : (i’m not too tech savvy , apologies for not best instructions to do it but here is what i could find .
https://forum.evolvapor.com/files/file/567-fcshare/
near the bottom of the page in link above , you will find a file called , EliteDNA75c.ecig.
go on to Escribe (you need to download software/program on your computer ) start Escribe , plug your elite , go on the link shared above , click on the EliteDNA75c.ecig link , click install or download and it should install on your Timber like magic .
i just installed it myself to verify it and it works. you will have to reset your cold ohm once the new file is uploaded to your Timber. it does measure it if you don’t know or forgot . just make sure your Timber is Cold when you measure Cold ohm .
otherwise you should be good to go
vape on!
