The heat rising from the element will eventually soak the unit and the load...a lot slower than conduction vapes though.
I just turn the unit off while continuing to draw to cool the load down if saving it for later.
Well done and keep it up! It is a big shock to the system to give up after so long, well done...vaping helped me kick smoking (nicotine as well)...would have been much harder without a vape or 2.
I have been told it will be available soon...no firmer time frame yet. A GonG 14mm male to whatever size you need with a bit of silicone hose works for me until the OEM release.
@Summer GFL Brilliant Cut Grinder is great, as seen here with a 'medium' grind type plate,
And with the capsules...no filter is needed,
I just tried a WPA hack, probably less secure then
@LesPlenty methods.
You need a silicone “Master Adapter”, they are generic and found on many vape sites, I linked to one from SneakyPete’s site, so you can see photos of them.
You need a proper sized screen, and if you have a 2nd “bowl/stem screen” from the ROFFU, it’s perfect.
Take out the small inner silicone plug from Master Adapter “MA”,
Remove the tiny white oring on the Roffu metal bowl screen/disc, as when I tried to insert it into the MA, I noticed the oring beginning to get pushed off the screen (it’s not needed for a good fit and can easily be lost), due to the soft but grippy silicone of the MA. (I didn’t want to leave my 2nd Roffu in the MA, so I found an Ambit regular mesh screen fit just as well),
I used the Roffu SS Metal Stem, the glass stem should work the same, but I figured I’d avoid any possible stress to the glass stem when handling. You obviously still need one of the Roffu stock metal screens in the stem for your load, over the heater.
After loading, push the MA, with your installed own screen or 2nd stock screen/disc, onto the top of Roffu glass or metal stem. It will push down to the bottom groove of the MA. BUT NOTE: The last inner ring of the MA is NOT VERY DEEP! This means you have to be careful when you pull the Roffu off your water rig when removing to clear, or it can come OFF.
I was able to hold my water rig in one hand, and using my fingers to pull up on the MA to remove the Roffu from my 14mm female joint.
NOTE: If you pull on the Roffu body, the MA can pop off the stem and DUMP your herbs out!
***So if you are clumsy or uncoordinated, this hack might not be for you. While it’s far from perfect, using a MA “Master Adapter” I already had, this works for me until they possibly come up with an official WPA. Now I can SEE my vapor production in my water rig.
The Sneaky Pete Master Adapter™ fits almost all vaporizers to any water tool with a female joint. The adapter itself is two separate individual accessories that perfectly fit together.
www.sneakypetestore.com
