Alright, test cart #1: This is very hard after rigorous testing, maybe I should wait till tomorrow. Well here we go...
I first checked for glow, it fired. I took a sherlock pull for flavor right after heater test, slight flavor... So I decided to do 1 minimal 2 second "preox" with taste pull after, and the flavor was very minimal compared to a normal carts first "preox" taste pull.
Continuing on, loading and priming went smooth @3.7v with some AA(less flavorful, but so clean!). The first pull was a little off, but also not nearly as much as before. Second, almost there.... Third pull was very pleasing! not quite TI, but what is. It was nice. I have been getting similar results with my pre-oxing, but I will do a side by side(w/old but new carts) to fully compare the result of our different pre-oxing techniques. I will check in again Sat or so with cart #2 to be filled w/NYSD wax/oil.
That just took an hr, i hope its as coherent enough for ya , it was tough, 110mg of testing has got my head spinning.
But, really, if ya'll don't want to deal with the "bad taste goes away with time" thing, pre-oxidize them until they come out with these.
Now were at 1.25 hr, whoa. Happy Holidays!
Thanks G