Borrow or get a cheap ultrasonic jewelry cleaner.
Drop it in there for about 10-15 minutes.
Even those stubborn beads SHOULD come out like brand new.
Good luck with those...
*ahem*
Blue Balls!
Happy Vaping!
Shall give this a go! I have one for my vapes so shall try it.
Careful. I have this image in my head of an airborne BB9 that ends badly...
It turned out fine
@junny89 Yep, I’ve had my blue balls stuck too. That’s fun to say. But seriously, mine are wedged (two together) at the carb. I’ve tried needles, washing, soaking...nothing moves them now. Really doesn’t bother me as I had taped off the carb anyway. Stuck Blue Balls, probably never type that again.
do what I did below, multiple times. And once released soak over night otherwise will get stuck again instantly.
Well, if they're stuck, I guess they must be sticky. Does "sticky blue balls" sound any better?
I'd like to find a deal like that on an '18 stateside just for the cap. Mine is well worn.
When I saw this I said "NO FUCKING WAY!!!"... Then I looked at it some more and sure enough "FUCKING WAY!!!"
Someone posted this beauty up on Thingiverse - and DynaVap is okay with it.
Tube -n- Stash no less!
Made on a 3D Systems CubePro v2.02 with ABS at 200 microns. Went together perfectly right off the printer. Printed at 175% actual size.
where is that available from ? I don’t have a 3D printer but I really want one.
ok so, I tried the boiling water and leaving the bb9 for some time.
While it did help it did not release the blue balls.
Then I used a tyre air pressure machine at a low pressure with a needle nose. Put it in all directions from front and back, and the carb hold. This helped.
However soon as I used it they are stuck again!
What I found is the balls are completely covered in resin until they are released and Re cleaned otherwise they jam up again!
I love the bb9 but I just wish them balls would not get stuck!
I find that if the tube was slighter bigger and more room for the balls they won’t get stuck.