Let me try to understand. The GH is so great you need to buy 2, and ideally 3 so you will have one to use when you have to send the others in for their monthly or bi-monthly RMA. They get so hot you need a silicone condom to save your lips from being vaped or a glass bubbler while using the GH as the heat source. So for around $200.00 you get an undependable vaporizer that looks like a thick ballpoint pen, gets hot when vaping, has sketchy operation, constant need to be repaired, and unreliable availablity. And this is great why?
Let me try to understand. The GH is so great you need to buy 2, and ideally 3 so you will have one to use when you have to send the others in for their monthly or bi-monthly RMA. They get so hot you need a silicone condom to save your lips from being vaped or a glass bubbler while using the GH as the heat source. So for around $200.00 you get an undependable vaporizer that looks like a thick ballpoint pen, gets hot when vaping, has sketchy operation, constant need to be repaired, and unreliable availablity. And this is great why?
And then there is the 15 second heat up time...
Let me try to understand. The GH is so great you need to buy 2, and ideally 3 so you will have one to use when you have to send the others in for their monthly or bi-monthly RMA. They get so hot you need a silicone condom to save your lips from being vaped or a glass bubbler while using the GH as the heat source. So for around $200.00 you get an undependable vaporizer that looks like a thick ballpoint pen, gets hot when vaping, has sketchy operation, constant need to be repaired, and unreliable availablity. And this is great why?
on my SS, from red to blue, cold to hot, the very first time, heating time is always around 6-12 seconds (more if really cold, like outside winter cold), then from warm to hot 4-7 seconds15 second? Is that the norm for your GH now? Or time to time? Something I have never experienced with my GH's.
15 second? Is that the norm for your GH now? Or time to time? Something I have never experienced with my GH's.
To be honest I think GHL should have sent out a free new front-end to everyone and also exchange the first fun of batteries for the second for free.
Hi has NOBODY bought or can give me a review on it??
for DDave mods
14mm Vapor Cooler *DRY* Flavor-Saver Whip Attachment??
http://www.ddavemods.com/store/p13/14mm_Vapor_Cooler_*DRY*_Flavor-Saver_Whip_Attachment.html
I don't normally answer like this, but have you tried searching?Hi has NOBODY bought or can give me a review on it??
for DDave mods
14mm Vapor Cooler *DRY* Flavor-Saver Whip Attachment??
http://www.ddavemods.com/store/p13/14mm_Vapor_Cooler_*DRY*_Flavor-Saver_Whip_Attachment.html
Thanks for both replies, I dont use water tools any more (too much air in guts and no flavour) and I do have my own cooling setup (dry) for both Solo and Hopper but it was another member that mentioned something similar if not the same by a different name that caught my attention. It might be $25 but add the $25 postage plus conversion rate and it soon jumps up to around guessing $60-70 AUD so I dont like to waste my time and money anymore if not any good.I have not tried that exact set up but for $25, why not give it a shot?
@DDave is known for having excellent mod options!
What i do is just use the hopper through an empty water tool.
I got mine today also, and feel the same as you. I think this will have me using my GH on the go more. I'm thinking @DDave Mi V2 cooler with this will make a nice dry/cool combo on the go with no extra parts needed!
As for the screen, mine looks like it may have been pushed in from the mouthpiece end? Looking inside the mouth piece, the screen looks like it has 3 "tabs" pushed up around the edge as if they were being used to create something digging into the sides to hold it in place. Like inexpensive spring steel fasteners that you push over rods and such. This would match the 6-7 pairs of lines scratched into the inside walls. These lines are the same width apart as those tabs. I can feel ever so slightly that they are scratches, but I don't think they will cause any problems including extra cleaning. They're not deep enough.
I'm guessing these early batches will have a few remnants of the assembly learning curve.
I'm not convinced that they open the airpath much either. I did a very unscientific test by swapping them back and forth and drawing multiple times directly thru them (not thru glass, etc.). I think the inlet is where the blockage is, if I start to pull hard, it has a lot of noise there......
The GH with PFE pairs beautifully with an Orbiter. The small size and hoses are really matched to the GH and its airflow. This could easily replace my Evo/Hydratube or HB Maxx/Hydratube night side table setup. It takes up almost no room, not much more than a can of soda and still delivers the clouds.
It's definitely a keeper
@jivebuggered That it is. V2's are all female pieces. V3 is the single piece Male cooler.Is this the same as your M1 V2 cooler? DDave mods
14mm Vapor Cooler *DRY* Flavor-Saver Whip Attachment?
If so is it really cool with hopper and easy to clean? Thanks
That's exactly what it is. I don't use it with water and it works great for me! I also use it with its intended vape the Mi, always dry and it works great there too.Is this the same as your M1 V2 cooler? DDave mods
14mm Vapor Cooler *DRY* Flavor-Saver Whip Attachment?
If so is it really cool with hopper and easy to clean? Thanks
@jivebuggered That it is. V2's are all female pieces. V3 is the single piece Male cooler.
To answer the question on how it works with the hopper, I must shout out to @AJS. His advice is always solid!
I can speak on cleaning the cooler, as I DO NOT use my Milaana or VapCap at home without one. I let mine get fairly dirty, dark golden coating in the first chamber which vapor enters the cooler.... and even this dirty, a soak overnight in ISO (70%) then a brief shake in the morning and she comes out spotless.
@jivebuggeredThanks DDave I will order one now there was no FC code correct? It`s $25 postage to Australia correct? Thanks
@jivebuggeredTo answer the question on how it works with the hopper, I must shout out to @AJS. His advice is always solid!
...story of my life.
Was that the pre-release "anticipation" vibe?If it makes you feel any better, it was the first I heard of it so i'm giving you the street cred!
Dude, there was this time in the GH thread where we all jived on the same vibe, and as an FC GH community, shared an epic broment.