It will be interesting to see what the Roffu caps will be when released, I am using the V3Pro caps with the on-demand mode at 180-190C(355-375f) and am still amazed at how quickly the Roffu pumps out vapor when used this way, caps usually slow things down at the start but they don't seem to slow things down here.The dosing capsules (XMax V3Pro or POTV One) brought the Roffu up to the top of my lineup
Can't beat them for convenience and keeping things clean.
Nope and been looking for a while, it’ll show up sometime, no hurry I can wait til they come out with wpa and I should really cut down on my vape purchases. I had an Anvil/accessory order lined up when it was in stock, but balked when total was over $400CDN. Paying in USD for a Canadian product did not make me a happy camper that’s what I paid for my Peak Pro which is the most I ever paid for a vape and I consider the Anvil is still in beta.
Not by the pictures, POTV1 has mesh ends, and V3Pro is stamped.
Shouldn't we all, but the economy needs stimulus. Go forth and spend....
Not exactly, but they work the same. I use either type in both the XMax V3Pro and the Roffu with the same results.
xvapeusa.com
thanks for the heads up on the sale.
I don’t have a V3Pro but the vapor path is short on the Roffu. It gets very warm. Especially if you use the 6 minute session or high temps at 3 minute session mode. I’m trying to like it. I just don’t yet. I keep going back to other devices that perform better.
I felt the same when I first got it. Then, I just turned down the heat and it was fine. It is a beautiful vape...
I’ll start at 160-165c and step it up 10 degrees C at second and third sessions. Even at the low temps the flavor is lacking compared to other convection vapes in my arsenal. I’m not giving up on it. Just not as excited about it as I see a lot of comments.
If i may ask, what else do you have in the arsenal? Id love to hear ur fave out the bunch!
what about the spiral zirconia air path? My understanding is if you were to stretch that out straight it would be a few inches long...way longer than the V3Pro airpath... and that of ANY vape this size tbh
so youve taken the MP out and just stuck a wpa on there but if i may ask a noob question, how does the flower nit fall out of the roffu? Like, where does the flower go or could you take a quick demo
he says at the beginning of the video "with a roffu filter above and below the load."
Ill need to see it im confused sry
The device comes with a spare filter disc assy that I simply install above the herb once the herb is loaded in the oven. Another easier way is to simply use a dosing capsule, just thinner vapor due to being a slightly reduced load, this was at 180c so even less vapor but better flavour.
