T-Bucket Banger System by NewVape
And personally, I think its a pretty great banger! Great for low temps, great for my fucked up lungs!
https://www.newvape.com/t-bucket-banger
https://www.newvape.com/t-bucket-banger
Bang on correct.
And the screws are the same as the dcup screws, the coil cover also, and the dcup 2's glass connectors are cross compatible too.
Baron23
Well-Known Member
Any issues in disassembly once gunked up....removing tube nut or getting insert out of Ti bucket?
Cleaning/disassembly I havent properly done yet. Its all due a clean, and I'll be ordering ISO in a few hours. Thought I'd get it good and gunked up to see where shit accumulates.
Zero stuck dish tho, not a single spec of reclaim under the dish, no matter how big the dabs. Plus, I'm using a one hole carb cap so if any oil could be sucked up over the dish edge, I suspect it would have happened by now.
I'll do some humongous dabs to check tho. You know, for science
Dubmonkey
Well-Known Member
Getting close to pulling the trigger on a TBucket set. Got my coojo Glass half bubble cap, cca710 sapphire dish, and just ordered a AugustHaus custom liger coil which I believe should bolt right on to the tbucket minus the cover. Going to run coverless for the coil. Hoping the side wall coil will be better at heat distribution.
Now to go locate a NV coupon code to obtain the tbucket set up...
will be joining the party shortly. Need to located one of those drop down oil catchers minus silicone container.
Now to go locate a NV coupon code to obtain the tbucket set up...
will be joining the party shortly. Need to located one of those drop down oil catchers minus silicone container.
This is the one I use but its out of stock atm - https://www.thickassglass.com/colle...catcher-drop-out-adapter?variant=587047698448
EDIT: Oregon Glass Blower do a few - https://oregonglassblower.com/GLASS-DROP-DOWN-ADAPTERS_c47.htm
Last edited:
what dish man?, bet that was a tasty sesh
Always with sapphire, no other dish compares.
Another win over the dcup... I get way less reclaim now. I suspect this is something to do with the heat being kept at the tbucket and the constant lower temps I'm dabbing at (415 atm)? My glass doesnt get hot... something something something condensation of vapour blah blah blah pulling guesswork out my ass something something something.
Or similar words that have more meaning and facts.
Or similar words that have more meaning and facts.
ensabbahnur
Hash Vacuum
Gotta say if this is true, and I'm not doubting it, its extremely impressive considering the Liger, with saph and even with the AH coil and extra shroud, never seemed to preform (big clouds) for me much lower then 520ish IIRC and a quick random sampling of the 3.0 thread shows most flavor chasers were bottoming out around 510-560, sure it could dab a bit lower but your clouds would be gone and you'd be sucking on it for 5 mins. I wonder what the difference is? Id think the carb cap is most likely better to what we were using but thats still a pretty remarkable improvement over such a similar device.
Did you check the video I posted? I know we all have different definition of clouds, and lighting can massively effect how clouds look on camera, but, out of interest, would those clouds be what you'd expect at 418f?
I suppose my PID could be reading wrong? But I seem to have settled at 415f for a good middle ground between clouds and my lungs moaning
I'll take a dish reading later with the digital thermometer and probes I have.As for temps compared to the Liger, I suspect the tbucket is more hefty weight than the Liger? The Liger looks thin and seemed to promote how much weight they lost with each revision. Maybe a side effect of that was the Liger losing heat quicker?
Never seen a Liger in the real world so Im completely guessing here.
Thinking of stocking some of these carb caps.
Thinking of stocking some of these carb caps.
Thats very pretty, I'd be up for buying one of those. I think @Dubmonkey has one of these in waiting for his tbucket
If the seal is good, it should work a treat!Whats that coil and cover in the photo?
Dubmonkey
Well-Known Member
Coil looks like a augustHaus custom Liger coil. The cover appears to be either something NV has in the works or that is a CCA710 coil cover for the AugustHaus custom coil. Got one of those August Haus coils coming so will be able to confirm fit once my TBucket shows up. Should be sometime early next week.
Was unable to source the CCA710 cover and doubt any will be available used or new without having to buy a compete cca710 Liger Air set up.
On the Coojo caps he has two options if I recall. One is for spinning balls and the other is more directional. Can’t wait to try my coojo cap on a TBucket. I also got a Dnail Channel cap queued up and ready to be tested on a TBucket. Will report back once get a chance to try the various options.
Was unable to source the CCA710 cover and doubt any will be available used or new without having to buy a compete cca710 Liger Air set up.
On the Coojo caps he has two options if I recall. One is for spinning balls and the other is more directional. Can’t wait to try my coojo cap on a TBucket. I also got a Dnail Channel cap queued up and ready to be tested on a TBucket. Will report back once get a chance to try the various options.