Nice. So the nut goes inside the bucket to secure the tube. And a set screw holds it on the joint end. Very good.
Any issues in disassembly once gunked up....removing tube nut or getting insert out of Ti bucket?Bang on correct.
And the screws are the same as the dcup screws, the coil cover also, and the dcup 2's glass connectors are cross compatible too.
Any issues in disassembly once gunked up....removing tube nut or getting insert out of Ti bucket?
Getting close to pulling the trigger on a TBucket set. Got my coojo Glass half bubble cap, cca710 sapphire dish, and just ordered a AugustHaus custom liger coil which I believe should bolt right on to the tbucket minus the cover. Going to run coverless for the coil. Hoping the side wall coil will be better at heat distribution.
Now to go locate a NV coupon code to obtain the tbucket set up...
will be joining the party shortly. Need to located one of those drop down oil catchers minus silicone container.
what dish man?, bet that was a tasty seshThe Weight organic rosin, 418f.
what dish man?, bet that was a tasty sesh
New personal record...
395f, decent size dab, down in two inhales. Big clouds.
Gotta say if this is true, and I'm not doubting it, its extremely impressive considering the Liger, with saph and even with the AH coil and extra shroud, never seemed to preform (big clouds) for me much lower then 520ish IIRC and a quick random sampling of the 3.0 thread shows most flavor chasers were bottoming out around 510-560, sure it could dab a bit lower but your clouds would be gone and you'd be sucking on it for 5 mins. I wonder what the difference is? Id think the carb cap is most likely better to what we were using but thats still a pretty remarkable improvement over such a similar device.
Thinking of stocking some of these carb caps.