StemPod by MPL
- Thread starter supershredderdan
- Start date
-
- Tags
- 510 box mod convection ecig
Highhowareyou
Member
Faulty mod for the most part, although I've noticed since switching to the rim C my avb is much much lighter, although I am waiting on a wismec rx228 to be the stempods new home
Highhowareyou
Member
I'm enjoying the stempod on the rim C and my wismec arrived today along with some quartz quest rod coils, however I have noticed that its difficult to finish a bowl on my rim C without the stempod overheating. It still gets me high but the bud is still a bit green so I figure I can push it further. Is there any way to prevent this atomizer overheat message other than buying a heatsink?
Highhowareyou
Member
GoldenBud
Well-Known Member
A friend of mine even uses 2 heat sinks for the Si using at 48W, atleast 1 heat sink is recommended according to him...
SpaceManWalking
Well-Known Member
I use one heat sink with mine and have never had heat issues.
Highhowareyou
Member
Where did you get your heatsink?
GoldenBud
Well-Known Member
Aliexpress, sort by Orders or check that the seller is not too new, check reviews too before buying
arb
Semi shaved ape
I use 22MM as the stempods base is 22.
The body fits down over the base making it wider in use.
The body fits down over the base making it wider in use.
How is this?
Last edited:
Shogun.
「Stand User」
I have that 2nd one, it fits and works well but note it took a month and a half to get in. POTV has them in stock as well https://www.planetofthevapes.com/products/sai-heat-sink-22mm
Summer
Long Island, NY
Includes a discussion on the upcoming DeskPod:
Leadpipe58
Member
I will be following this thread. inserting.
arb
Semi shaved ape
Inserting?
Made some ridiculous 13 wrap coils out of 22 gauge kanthal wire.
Takes a full 9 seconds to show color from a cold start but that mass........milky.
Took around 5 minutes to make and another 2 minutes to install and will last months of heavy use.
Link is dead.
Anyone have a copy of these?
For TC on stempod with Clapton coils ...
Thanks
Hi, does anyone's stempod Si pull apart when they try to pull out the glass stem? Mine entirely seperates from the coil base! Does everyone find that's the case and they need to hold it all together when pulling their stem out?
if so. Any ideas on how to tighten the hold that the rubber rings have on the coil base to the metal tube? Or any idea how to make the glass tube a little easier to slide in and out of the si?
Ps. I bought two si's and one of them does not do this..
if so. Any ideas on how to tighten the hold that the rubber rings have on the coil base to the metal tube? Or any idea how to make the glass tube a little easier to slide in and out of the si?
Ps. I bought two si's and one of them does not do this..