Search results

Cut a mesh screen to size and stuff it down into the thread. I have more of them, send me a PM with your order no / email.

You'll get slightly better extraction with using the half bowl setting for half bowls, mainly because the bowl can heat through a bit quicker there.

If yours has the black or green o-ring under the heatshield then that’s the only one which is not ISO safe yet, but you can soak it until the release, it won’t be a problem. All the other oring are ISO safe

You should be able to push it in completely. Did you take off the o-rings? The one that’s deeper in the stem is a smaller o-ring (5x1mm) than the other one. It’s made this way so that you can use two of the 6x1 to make it tighter if needed for glass. No you can’t close the air completely on the...

It's still heating just much slower. If you listen closely you can hear it activate for a fraction of a second repeatedly.

290-320C until time out OR 400-420C until the blinking stops. The 400C is until the blinking stops, that's probably combustion at the time out I think

Yes it’s 8mm

Please check the picture and the video I posted yesterday to see how it comes apart. The SS tube slides off, however it’s slightly oval so you want to pinch it at a specific point so make it round and then it pulls off easily. The VI that I marked with a red arrow is also Ti. Yes, just do an...

It has a different threading unfortunately :(

Here is the updated indicator installation video:

Both just like on this video, but the clicks would happen a bit later. Yes, I'll make a longer video where I take it apart and put it back together. It will arrive assembled.

Eventually, it’s planned. Probably not before the end of next year. You can’t use the DV screens. It works is half bowl if you don’t go too crazy on the screen when debowling.

There is a link included with the kit for the unfinished manual. Thanks for all the orders, I guess I should've got more again... hopefully it'll be ready soon! :tup: This is how the indicator moves in the wand:

I never remove it, neither the heat shield. Just pull out the CU until the o-rings are visible and remove the bowl.

The thread should be very loose, that's on purpose so it can't get stuck, even if you have some bits in there. It should work smoothly as long as you're trying to screw it on straight and fairly gently. You don't have to turn it slowly, just don't press it too hard. Let me know again in a few...

I don't plan to do more of them currently unless there's a lot more delay. The timer is up on the product page It’s happening at the exact time, no waiting this time. Ti only.

Same price, the currently missing accessories will cost as much as the discount on the early kit.

yes, raw ti only

I can help with that, just got some more indicators and have a few of the Ti's prepared from last time so they're now available on the website. All o-rings iso safe and likely final visual indicator, uncalibrated clicks.

Not much unless you pack it very tight, helps with the airflow slightly. That’s normal, this is how it should look: