Search results

Ride the line, just before combustion

You can close the airflow on the cap as well to make it much tighter. Undo the screw on the cap slightly and squeeze the induction layer at a specific point to turn it. I'd recommend using the "time out" method on the wand when outside, it helps to pre-heat the bowl with the longer heat-up...

Cut down 2 lines worth of silicone from the adapter, it’ll be much easier to see. Push the glass to level with the black plastic case around the red silicone for the most optimal heating position.

Yes, you can pull it hard, it can’t break. If it doesn’t come apart then you can try to heat it a little or iso soak. Spinning MP section, check the location of the o-ring to make it “locked”

Thanks for the first impressions :tup: If you have a reload then I don’t recommend using the debowler, it works slightly better without it because of the reduced mass. If you do use it then increase the temp on the wand by about 75F compared to my recommended setting

Yeah just heat it up once with an empty bowl after cleaning.

Yes you need to purchase a kit with free shipping

No there wasn’t, the next one is expected around the end of next week, about 50 of the raw Ti. With likely final visual indicator and not final click/s.

It is

Thanks for the initial impressions / review :tup: You can use the visual indicator in the wand as well if you cut the silicone part a little shorter (about 2 lines) or push the silicone into the wand first so the bottom of the glass is visible with the indicator. Which is actually the opposite...

Yes, I’m waiting for the first prototype.

It works fine as long as the tube is pushed in properly. The inner o-ring is tighter on the new one so it should stay in place well.

Yes that one Yeah it’s no problem, every finish should be fine

I can only say for sure when it’s ready, but seems like the colors will have to be slightly more expensive unfortunately. The presale will only include extra parts, it won’t be cheaper than the regular retail kit price

You know that you’ll get the proper click disks at release right? :D I have some more now, if you’re happy to install it drop me a pm

You can control the airflow on the cap as well. The induction layer can be rotated if you press it at a specific point from 2 sides and loosen the screw a little on the bottom. Don’t forget to tighten it back properly so it won’t stick out and scratch the magnet. You can use the Reload’s...

It’s a slight design change that I didn’t ask for :doh: It really is especially without being there and seeing the issues straight away. Yes it’s planned for the anodized colors, the pointer / gauge is Ti.

The new batch of visual indicators are not great unfortunately, the shape is slightly off and it can’t be adjusted manually properly. This means that I have to wait for a new batch again to be able to do the next drop. It’s going to take at least 2 weeks I think.

That’s right, but the Blurple will be available as well at some point if I choose the other one. It didn’t sell as well as I expected the last time so it’s not planned atm. It will take about 10 days in total, the dpd tracking is slightly behind. About 5 days for the next update after it’s...