Hey guys, would one of you be kind enough to dm me the calibration instructions?
First, please open the battery lid and close it to reset the device.
Turn temp dial to lowest value
Do triple click, like you would when turning it on. If you did it
successfully, the back end LED light should show very shortly green
light, like 0.1 seconds and the vibration motor makes quick burst of
Wait a few seconds and repeat. You should count that you get total of
5 of these short vibration / green light flash reactions. Not less and
not more, exactly 5.
Then turn the dial to higher level, like 5 and do the turn on with a
triple click. Your vape should start vibrating continuously and back
end LED activated. Don't press anything but turn the dial. The color
should change. When turned to low level, the light should become blue.
This means -3 steps for temp calibration. Vape should still vibrate.
next is purple, level -2. then turqouise level -1. Green 0, this is
usually the default level the vape ships with unless we had to improve
calibration ourselves. orange +1. red +2 and finally white +3.
Choose the level you wish by adjusting dial, for maximum temperature
choose the white.
Now you should press and hold the button without releasing it until
all vibrations have stopped. Only then the setting will be saved to
flash memory of the Tinymight. Maybe 5 seconds it is. Anyway, finally
red color is on at the back.and no vibrations. Now turn off the vape
Next time you turn it on, the new setting is in use and your temp dial
should be working differently. This feature was not intended for the
end user when designing the vape so it is not very user friendly and
for example there is no way to check which level you have chosen in
this calibration adjustment process. But it works and can be repeated
as many times as wished.
If you happen to not be successful, to get the unit vibrate
continuously, you should remove the battery lid and close again to
reset it and start again. It is important you get exactly 5 times this
lock signal green flash of light and short vibrations, and only then
turn up the dial and start normally and it should be in the setting