Highlighter DIY kit arrived today!
5 minutes to assemble, not sure on heat up time but it was quick, and a few small baskets later I was done...
Now it's time to customize this bad boy!
Adapter does not quite fit right when the screen that holds the balls is all the way down. I may try placing the larger screen upside down to prevent this and to have a bit more room between the mass and the herb.
Need to fashion up a nice wooden handle for it as well.
The twisting of the wires did not turn out nicely for me, so I will wrap them in some cotton threads or something.
I will also be adding some extra 3mm beads to stop the rattle.
In its standard orientation with the mass close to the herb, it is a killer vape! I started at around 7 volts and went down to around 5, this thing will combust if you turn it up too high.
@RedEyeFlightControl
Congratulations, this is a winner!!!
EDIT:
Inverted large screen, I trimmed it even so it sit flat. I then dimpled the screen down a bit to flare the edges out for a springy type fit.
Added about 20 or so more beads as well as a thicker viton o-ring I had lying around. I placed this over the red shrink wrap and it holds the lower o ring in place nicely.
Cranked up the volts to about 6 and its an absolute beauty now!
Slightly tamer but it retains that serious punch!
Pack the EQ bowl and let her rip!
Thick delicious vapor that will not stop! The whole bowl is a nice golden color in one hit, top to bottom!
Just keeps getting better!