New Portable H Enail with built in glass bubbler by Green Light Vapes

Hoosier

Well-Known Member
I highly doubt temperature control would work... Though finetuning the wattage might already give the user a big advantage over the stock battery!

I think the primary benefit will be to milk out low temp dabs with pulsing control with minimal waste. It's also a nice little addition for someone who already has a big mod rather than adding yet another proprietary device to the rotation.
 
Hoosier,
  • Like
Reactions: zikzak

Fkn0wned

Well-Known Member
It seems to have a bigger Ti nail also and I'm thinking it should allow you to take bigger dabs as well seeing as how you have control over the heat where as the standalone has a short run time once you have started the heat up process.

I'd like to try one of them out I mainly use a Hercules on my VTC Mini but that left my IPV D2 just sitting there collecting dust I could use that on there but I am not really seeing the point for me to jump on it when I own a standalone device.
 
Fkn0wned,

zikzak

Well-Known Member
I'd like to try one of them out I mainly use a Hercules on my VTC Mini but that left my IPV D2 just sitting there collecting dust I could use that on there but I am not really seeing the point for me to jump on it when I own a standalone device.

Similar boat, my standalone just came today and I got it unpacked (letting it get to room temp first, it's like 0 degrees here and all the components are frigid). My daily ecig / DT 2.5 driver is a IPV D2 (Uwell Crown instead of a Hercules tank) though and I have a big honking DNA 200 Reuleaux (nice gift from Vape shop owner friend) that's the one collecting dust for me (I know, I know...what a shame such a nice mod doesn't get used daily, but it's freaking to heavy and I'm not that big of an ecig vaper).

As much as I'm tempted, I'm going to let some others report back to how this H ENAIL w/ 510 base works out and then go from there.

It would be damn near perfect if by some miracle it did have TC along with a larger Ti nail mentioned above, but that's probably for future iterations and wishful thinking at this point.
 
zikzak,

tepictoton

Well-Known Member
Use mods myself and have been watching this closely, so sorry if my first remarks came of a but harsh.

Thing is, make it temp control and fit an 18, or second choice 14mm female fitting and you have an all round winner in my book.

But I do not see this working well inverted, and without ability to hook it up to a water tool I personally loose interest again...

I think I might actually not be someone that really really needs an in the go nail solution hihi... Still seeing how this develops in a daily base sure is fascinating.

Edit: I can also say you are probably going to want a heat shield on top of your mod when using this toy... Even more if it would work inverted.
 
tepictoton,

iDRINKBLEACH

knowing is half the power - Gi-JOE
Accessory Maker
I need a new glass piece broke mine first day. :( for only $8 more I can get the 510 attachment, thats a no brainer.
 
iDRINKBLEACH,

anasrzi

Well-Known Member
Got a new slotted glass mouthpiece on route, I didn't mind the small holed version but I do have to hit it pretty hard to get all the vapours coming thru so I'm looking forward to getting a dab done in a single hit (which I assume is the whole point)

Check out this link guys seems like there adapting the h enail into a dry herb model aka "k aspen" not sure how these would work for vaporising looks to me more like it will cook the herb beneath like a general coil type dry herb pen but not sure, looks like it comes with a ceramic donut as well for oil dabbing.

http://www.dhgate.com/product/h-ena...00mah/370884739.html#s1-0-1b;searl|1149625651
 
anasrzi,

zikzak

Well-Known Member
Check out this link guys seems like there adapting the h enail into a dry herb model aka "k aspen" not sure how these would work for vaporising looks to me more like it will cook the herb beneath like a general coil type dry herb pen but not sure, looks like it comes with a ceramic donut as well for oil dabbing.

http://www.dhgate.com/product/h-ena...00mah/370884739.html#s1-0-1b;searl|1149625651

Interesting find, I'm trying to make sense of how one dabs with it in the traditional sense, it looks like that black screw top with holes in it has to be used to allow a mating option for the glass diffuser / mouthpiece.

Another wholesaler has them, http://www.dhgate.com/store/product/2016-newest-h-enail-kit-gr2-vaporizer-pen/371008267.html

What also (aside from the ceramic donut, is that tiered??) has my attention is the large jog dial, voltage or temp control? I don't know. It looks like the included instructions that are displayed in the ad are not updated for this particular iteration.
 
zikzak,
  • Like
Reactions: anasrzi

tepictoton

Well-Known Member
The large toggle is supposed to be Airflow control if I am correct

Edit: still can not figure out how this would work with dry herb? Where would Airflow come from? What is supposed to be the bowl? Is it heating the air that enters the bowl or the bowl itself?
 
tepictoton,

Danksta

Well-Known Member
Looking into getting one of these. I also need a new pen. Would you guys recommend this over a new pen?
 
Danksta,

Critronton

Well-Known Member
Looking into getting one of these. I also need a new pen. Would you guys recommend this over a new pen?
I got both this and a ceramic 510 nail for my istick 40w battery

The enail is for portability and the pen is for stealth usage.
 
Critronton,
  • Like
Reactions: Danksta

ru_frothi

Portable Vaporist
Picked up one of these and a few spare batteries.....

So far so good...

Love the charger:
Useful information and simple to operate.

and so far these LG batteries are working fine....

and boy... the Kaizen combat cookies taste so good on this....

and I have to this Kosher Kush is pretty incredible. Kaizen is pretty new but I find their extracts on par with Mag and Utopia.
 
ru_frothi,
  • Like
Reactions: zikzak

studmuffin

Well-Known Member
Greetings, I have been using my Greenlight G-9 H-enail for about two months now, and I would like to share my technique, which is a serious departure from traditional dabbing protocols. For me, I quickly grew weary of fumbling with the dabber/carb cap during the process. So, this is the method I use now, and it is very much more "user-froendly" , and yields mega hits/clouds that, as my grandpa used to say, "Son, this will knock yer dick in the dirt". I realize that the females among us will have to cross-translate this sentiment into a form which is applicable to their gender. Forthwith: Instead of "dabbing" concentrates onto the nail, before I even turn my G-9 on, I roll a tad bit of BHO wax (89.2% THC, my friends) about the size of a lentil in my fingers, and smash it down onto the Ti nail so that is goes down fully into the "cup". I placed the water-filled glass piece onto the body, with the carb cap (sans dabbertool) seated onto/into the glass piece and press the power button three times to begin the first heat cycle. When I see vapor begin to emanate from the vent hole, I take my first draw. This is always before the green light comes on. With the first draw, while holding the vapor in for about ten seconds, I press the GO button three more times, after the green light goes out, also while covering the carb cap vent hole with my thumb. I then take another monster draw, producing serious milky clouds, and cover the vent hole to prevent vapor from escaping. After holding the hit for about ten seconds, I press the power button a third and final time, keeping the vent hole plugged until my next mega monster draw. All total, I get about ten tokes, more or less continuously, once I start my session. Usually, after "my dick has been knocked into the dirt", I scrape the inevitable glob of wax that has bubbled up to and become affixed to the underside of the carb cab, which I "recycle" back onto the nail for a finishing "Shit the bed, Ted" single heat cycle. At this point, which is after about a three minute sesh, I have a mental acuity located somewhere between a brick and a potato. Schwennnnnnnnnnggggg ! I know that this method is "off the well-beaten path", but dang, the result I get is stellar. Try it, yoiu might like it ! :peace:-n-:love:
 

zikzak

Well-Known Member
^ Interesting technique.. I'm going to try a modified version here in a few minutes with only 2 power cycles (stuff to do later, haha).

On an related note of HENAILs

Anyone seen this from cloudvapes? Interesting loading, steamroll, carb design. Power levels go higher due to higher capacity battery-- but the battery looks to be proprietary and so having to deal with charging time layover could be a drag compared to being able to pop in a fresh battery (or 2, like I imagine we'll see in future HENAILs).


https://www.instagram.com/cloudvapes/

http://cloudvapes.com/store/index.p...-portable-enail/cloud-electro-portable-e-nail

$249, pretty steep-- but they gotta pay for all that marketing and usage of Tommy Chong's likeness for other products of theirs somehow. :)
 
Last edited:

Fkn0wned

Well-Known Member
I was not familiar with this personality until doing a google search just now. Thanks for the insight haha

Yeah I just stumbled across one of his videos in a compilation thing I watched one time I think he is just making a play on the whole "vape" scene lol.

Idk it's kind of ridiculous some of them have made me chuckle before.
 
Fkn0wned,

Harmoniousliving

Well-Known Member
Grabbed from one last night...should be here Wednesday. The glass has the holes not slits. Is that what I want ?
Thanks guys
 
Harmoniousliving,

Hoosier

Well-Known Member
Grabbed from one last night...should be here Wednesday. The glass has the holes not slits. Is that what I want ?
Thanks guys
Nope. The newer units with slits never clog vs. the older ones with holes clogged (sometimes immediately). The slotted ones also clean out much easier.
 
Hoosier,

salivape

Well-Known Member
Got a new slotted glass mouthpiece on route, I didn't mind the small holed version but I do have to hit it pretty hard to get all the vapours coming thru so I'm looking forward to getting a dab done in a single hit (which I assume is the whole point)

Which seller did you get the slotted glass from? I've been offered a dhgate unit at cost but it has the old style bubbler. I'm wary because the guy who's selling me it was promised the slotted version and didn't get it.

Vapefiend have them, but if I can get 2 from China for the same price I'd rather do that.
 
salivape,
  • Like
Reactions: anasrzi

anasrzi

Well-Known Member
Which seller did you get the slotted glass from? I've been offered a dhgate unit at cost but it has the old style bubbler. I'm wary because the guy who's selling me it was promised the slotted version and didn't get it.

Vapefiend have them, but if I can get 2 from China for the same price I'd rather do that.

Got mine from here

http://www.dhgate.com/product/repla...x-dry/270171561.html#s1-4-1a;searl|3979194703

Only reason I went for this seller was that he/she/they knew what I meant when I said about slits or slits opposed to small holes, few other sellers seemed clueless even when I asked them about the ones they sell. All the ones for the above link I've been confirmed personally that there all slotted so you might be best getting one from them, mine was shipped in two days and is currently on route.

Would have to say they slotted one is the one you want so I'd steer clear unless he posts a image showing the newer glass piece, wary myself even ordering from dh gate but that's only due to never doing it before. Only reason I got mine from vapefiend was the warranty that's all otherwise I'd get one cheaper else where but I'm very happy with mine :)

Your avatar looks familiar @salivape to me, you at a certain sharing site?
 
anasrzi,
  • Like
Reactions: salivape

salivape

Well-Known Member
@anasrzi No not me. Just an image I stumbled upon that matches what I'm about haha

The guy who I'll buy it from is in the UK. He ordered a few to sell but isn't happy with the old bubblers and isn't having any luck getting replacements. For that reason he doesn't want to profit from the sale. It'll cost the same to get one from dhgate even with having to replace the bubbler plus faster delivery so I figure it's worth it.

I'm fed up with torching a nail but I don't want a hot enail around me all the time so this seems like the best bet.
 
salivape,
  • Like
Reactions: anasrzi

WakeAndVape

VapeLife X
I highly doubt temperature control would work... Though finetuning the wattage might already give the user a big advantage over the stock battery!
Why would you doubt it?

The description says it fits TC mods.

TC works with TI. I would think it would work unless there was evidence to contradict.
Just curious why someone would get the 510 version over the "full kit" version. Is it just to save money?
No I have the full version but am more excited for the 510 version.

The coils I make for my TC mods crushes the h-enail. It's just a little harsh on the throat.
 
WakeAndVape,
Top Bottom