Firewood Vaporizer

[Delta3DStudios]

That's exactly, what I am getting at, try lowering your settings even further, that is why I like to run so low, the heat builds and retains, so can get full extraction regardless

How long are you pre-heating the trigger before you start your draw?

 

[Shit Snacks]

How long are you pre-heating the trigger before you start your draw?

Well it does vibrate when it is ready so thats automatic... First hit or so might wait a little longer if you want to see more vapor sooner, and draw extremely slow so as not to cool it off too fast as it is heating up still, drawing faster as you go, fastest once you let go of the button and after it vibrates to fully clear...

 

[PersonDude]

Apologies if this has been answered in the thread already but I honestly don't understand one thing, how do you get the storage base off of the FATX to get at the mouthpiece adapter and latch?
The website shows how to take out the mouthpiece and put the storage pieces back on but not how to take them out in the first place. I can get the lid off easily but I honestly have no clue how to get the storage base out. Can I get a little help?

 

[XoGnosis]

Apologies if this has been answered in the thread already but I honestly don't understand one thing, how do you get the storage base off of the FATX to get at the mouthpiece and latch?
The website shows how to take out the mouthpiece and put the storage pieces back on but not how to take them out in the first place. I can get the lid off easily but I honestly have no clue how to get the storage base out. Can I get a little help?

It is shown in the manual (available as a PDF if you don't have yours available), just after the chart of clicks vs temperatures. In a nutshell, you'll take the mouthpiece out, flip the unit over, and push the storage base out the first few mm THROUGH the hole where the mouthpiece exits the wood body.

 

[PersonDude]

It is shown in the manual (available as a PDF if you don't have yours available), just after the chart of clicks vs temperatures. In a nutshell, you'll take the mouthpiece out, flip the unit over, and push the storage base out the first few mm THROUGH the hole where the mouthpiece exits the wood body.

That part of the manual was a little confusing for me but that explanation made it make sense! Thanks to your help I got the adapter out!

The only thing I'm struggling with now is how do I fit the adapter spring back inside the device before I put the storage bits back on?

 

[stonedBBer]

What are the default temps on the fatx. I can't count the vibes well.

Is there still unregulated mode.
Only have 3 bowls on it so far with the default stem but it is niceeeee

 

[PersonDude]

That part of the manual was a little confusing for me but that explanation made it make sense! Thanks to your help I got the adapter out!

The only thing I'm struggling with now is how do I fit the adapter spring back inside the device before I put the storage bits back on?

Ok so I did it myself and even though idk if I did everything right, the device still all fits together and breathes good!

In case anybody else is having an issue with the spring, the way I got it in was focusing on the two small divots before the grooves for the storage parts. Make sure the tube of the adapter is upward like in the manual and you should be able to slot the spring in the little divots. The manual says that it should push the adapter into the oven and that's why you should angle the pokey end bits toward the adapter.
It made a noise that I'm not great at describing like a kind of "shrrk" sound when it slotted in and I don't know if that's good or bad but it made it fit!