There is something inspiring about the ISpire and I think I would be a customer if I didn't already have 2 Pipes IHs. The temp control is very attractive as I think a slower heat up may be a good thing.
It looks like you have thrown a M to M on your GooRoo 3 piece so that you could use that fat mouthpiece stem with it. While I love the GooRoo mouthpiece, I often use a different MP as well to get a little further away from the piece for a better view. My 2 GooRoo pieces are also the most expensive pieces I have other than a recycler that I rarely use.
I have a SourceVapes Alpine '21 and a Pipes HotShot... the iSpire is a different animal... different from any other IH I've seen. And remember, this thing was never designed to run a dynavap, not in the slightest... they had absolutely no clue.
first off, the "oven" is a bottomless hole.... which means you decide where on the tip you want to heat it, not some stupid momentary switch and whatever else you throw in there with it...
next, because the oven area is much wider in diameter, you can easily spin a tip while heating. Does spinning a tip in an IH even DO anything...? I think it may, but I'm still not 100% sure...
third, and a big one for me, is that I usually use the wand much like sparking a bowl with a regular old Bic lighter, heating the tip whilst drawing (and spinning, if I want).... I start pulling when I start seeing the first wisps of vapor and then just watch it build...and stop when I choose.... the clicks themselves are really nothing more than a rough guide at this point.
Afaik, despite the marketing, there is no actual measured "temp control", per se, just profiles that are supposedly fairly accurate.
and on top of that (I know you don't do trates) it actually handles concentrates pretty nicely for a "portable" electric.... way better than any dab pen-like device I've ever used. And certainly way less cracky than using a torch ALL THE TIME.
just because it's an IH, it does not make it the same or even similar, as anything else on the market.
is it for "everyone" with a DV...? No, I wouldn't say so... too much variabIlity as it stands out-of-the-box today.
As for the Goo Roo 3-piece mp... pictured it's on the Dabbing Warehouse bubbler and the 3-piece is using the Sticky Brick Hydro Maxx mp with an 18mm male to 18mm male adaptor. As I've whined about it before, even being a hair under 6' tall, the Goo Roo with its stock mp stands a little too high for me to comfortably sit at for any length of time at desk height... plus I also like to be a little further away, like you, too...
)
www.421store.com
) I'll say that my SunshineStore order finally got to New York it seems! So hopefully I will have that this week, need that female to female adapter to use the Yingmin footed hook, not to mention the two heady male rigs that are enroute...
)
):
