EddIW
Well-Known Member
Baller head filled with 3mm rubies + .3g flower. Didn't think it got better than a capped VROD but the baller is something else imo.
ty, for counting all those balls lol. using the baller nut as well?With 3mm extraction happen more quickly, a bit darker roast at the same temps as 4mm, a bit more restriction, and you can pull more fresh air without as big of a temp drop.
oh for sure, they are designing a new carb cap around it.Really hoping that the baller top nut makes another appearance.
Is a cap required?oh for sure, they are designing a new carb cap around it.
No cap needed with baller head, unless also doing a dab.Is a cap required?
I was hoping the baller head would negate need.... The videos I've seen have been cap less....
Yes it is. The OG Baller has drilled holes similar to what the VRod looks like. The Screen Baller just has one large hole and uses a screen. They should add a picture of the holes on the OG Baller Head underside on their site.Curious about the baller nuts as well. So the "screen baller" is different from the "baller head"? More airflow? Bigger chamber for balls?
If anyone considering, they have sold out!because I'm weak I've ordered the baller head...... couldnt resist.
Urbanistic in UK are suppliers. I noticed they have sapphire dcup dishes (wish Id ordered from here to save postage and customs) also.
not sure if they supply EU but as I have my best buddy coming over in a couple of weeks he is bringing it over.
Baller Head Assembly
Introduced in Aug-2021 The Baller is the newest head designed for the flowerpot ecosystem. We started with the legendary Vrod head and machined away the inside to accommodate 58 Quartz 4 mm spheres. This design more than doubles the heater's surface area. Instead of the straight air channels...www.urbanistic.co.uk
u getting any woody flavors? i keep seeing this im curiousBalling out with the OG. This is very smooth and flavorful. Maybe I do need a Jhook? I’ve never owned one
View attachment 13766
It's the same one CH lists.Almost gave in and ordered the screen baller direct until I saw the shipping was as much as the part . @VGOODIEZ is the baller head you have listed the screen one or the one that still has the holes at the bottom?
They now have both listed on their main products page.It's the same one CH lists.
We have this one here.They now have both listed on their main products page.
Damn dude, good point. It does seem well seated in the groove but that is definitely something to take into consideration.My luck, it will somehow dislodge and little 3mm hot rubies will be bouncing everywhere.
Seriously. I need one more. I’m really enjoying the one I have.Where’s the baller nut!
Baller IMO. I'm also flower-only and it's given me the best uncapped performance.Hey everyone, I currently use my VRod head for flower only and am looking to upgrade for better / more even performance uncapped. Am I better off getting the baller head assembly or just getting the weedeater head? Thanks.
Yeah... I got my screener during the first wave and had to install the screen myself. Required a bit of deformation, so even tho it seems secure, it kinda bulges and looks like it could bust. Zero worry, doubt, etc with OG.Here is what “may” make me use the OG over the screened. The screen. My luck, it will somehow dislodge and little 3mm hot rubies will be bouncing everywhere. Not a problem with the OG.