https://imgur.com/a/yo1hx
I've been messing with wax/budder/shatter and tried a bunch of different bullshit you can buy like the divine tribes 2.5 donut (haha it's a joke compared to this)
I've mostly been building on evil monk postless rdas. Tried some 500 SS mesh and I can't decide if I like that or the ceramic better but the FC-2000 wicks like you see here don't have any taste accompanying them aside from what your smoking and honestly they wick about the same but I seem to have more reclaim with the mesh.
This is a new build for me... I used a torch to heat 25g kanthal as I wrapped the fc2k rod. It came out way nice then my last one. It's a 13 wrap and 1.5 ohms. Everything else I've been building has been sub ohm and this honestly hits better maybe just because of the coil quality. You can get one really big hit off this ONE rod.
It's a phenotype l RDA clone base that was not machined nice and it was hard to pull the top off of so I put a Doge v2 authentic on top. Works great comes off nice and easy but still seals.
You can really saturate the whole rod and at 13.5w it's a good few seconds before you get a light red glow. I close the airholes about 80% of the way and take a 6 second rip and it's POOF.
It runs nice on 13.5 watts.
For comparison
this is one of my old builds. Still hit like a champ but doesn't compare.
I did not hot wrap. No matter what I couldn't get a nice wrap even with thin guage..it'd be too springy. Took out the blowtorch this time and it was cake.