Recent content by vandalizedbythelotus

that's great news! any chance we can get a discount for early adopters who already bought the old ones and gave valuable feedback on what to improve? thank you!

i was under the impression the saucer was the latest iteration (correct me if i'm wrong). a bit surprised they are making the older one instead of the newer version.

& @mysiak IME this is the same way they run the vapman site ... "Shipping calculated at checkout, VAT excluded"

ordered! do you guys think the delivery estimate is accurate? or is it more likely they will ship after the july 1 official launch?

perhaps a steel plate option for IH's could work

sounds about ambient temp. you sure it's not in on-demand mode instead of session?

i think it's more like a beast mode session, with automatic temp stepping, going up to the max temp meant for herbs. i'm sure the heater goes up to the same 464f in wax mode. p.s. both my units bottoms spinning

i really like the updated italian design because it's fully serviceable. everything can be unscrewed, replaced, cleaned etc, even on the mica version. kinda wish they sold all the parts separately.

eh i tried flat screens before bending them, but the cooking was a bit uneven. with lighter AVB in a ring along the top edge of the oven, where naturally the temps can't be as high due to how it's built. the domed screen basically cuts that part out of the bowl and gives me completely even...

step 1: pour the herbs into the oven from a container or with a makeshift paper guide. keeps mess to a minimum. step 2: don't overfill, don't pack tight. convection biased heater works best with a fluffy load. step 3: domed screen and slightly diminished load ensures even extraction, no...

not yet and according to the rep here they already have a roadmap for the near future which doesn't include capsule rework. ATM they are heavily advertising the current caps, presumably trying to offload existing stock. i think there's no reason to expect a rework in the next 6 months to a year...

clean/wash the entire airpath as well as possible, run some max temp burn-offs (session mode), let the device air for a couple of days. had the same experience with my regular AVLP and V3PRO, hot plastic aroma went away after a couple of bowls.

but how? is there solder or anything to bind the inside cap to the outer armor, for better heat transfer? or is it like installing a CPU cooler without the paste?

they actually improved it a little since. the door on my replacement unit (from the latest batch presumably) swings and closes tighter than my previous 2 units.

almost 1m to get up to temp seeesh ... i'll wait for unbiased reviews.