Concentrates for Noobs - Q&A

invertedisdead

PHASE3
Manufacturer

show me what you got brother

I haven’t vaped herb in probably close to 2 years now - i honestly just roll joints if i have herb now lol :freak: its just very rare i even bother tho

I haven’t shown off any of my extract stuff just yet but I can say I started from a total ground up redesign of the entire system to address all the thermodynamic discrepancies :freak:
 

Bologna

(zombie) Woof.
True wisdom has been bestowed upon me here; really efficient experience--absolutely love it. :nod:
I'll have to try the 6-stack knot soon :science:
Ty, kindly... 🙏🏻

And I'm with you and @Shit Snacks...! Can't wait to hop on da knots...! :sherlock::rockon::



Just under the wire... BOOYA! :cool:

Edit: oh yeah, they gave me sooo much free shit when I bought the Biao.t rbr clone, I just HAD to tip 'em this time... karma, Kramer! :tup:
 
Last edited:

Bologna

(zombie) Woof.
Well, they arrived today and first impression was pretty fuckin' good, I must say...! 👍🏻
23d8e52c-f090-410b-a102-516a41c11bca_text.gif


After I cleaned the 4-stack knot I turned the Old Head coil up to 700f and just placed it in there even tho there was a good 2mm gap all around... waited a few mins til everything settled, put on my heat resistant silicone fingertip booties, grabbed the knot and placed it on the big Goo Roo drop-down and dropped less than a grain of rice of live resin and pulled.... really nice easy flavorful hit! Very little residue so it burned off quickly using my antique pencil torch and propane canister... no need to waste the Big Shot butane on that... sweet "new" (to me) option! Thanks, @Shit Snacks!
 

Ramahs

Fucking Combustion (mostly) Since February 2017
yes. i have a 4 hole and i prefer to use my quartz pi cap over a marble. cover the hole to spin and uncover to carb.

Thanks for sharing your experience/opinion. I have bubble caps, so I'll of course try them as you suggest.

My reasoning for getting the marble was going off the last time I used a carb cap that way (finger on the hole controlling the air), in which I found I preferred to keep my finger on the hole in the carb cap, and still just lift it up slightly if I wanted to let air in. I found I had better control on the airflow that way.

That being said, you may be completely correct and I wont like the marble. But in that case I still have several carb caps I can use :tup:
 

Kirudub

Well-Known Member
This might've already been covered, but there are too many pages in this thread...

I got some moon rocks last week, and there was a lump of concentrate on the outside of a bud, so I peeled it off (not sure what type; it was dense and tar-like in consistency, but not terribly sticky).

This was also when I realized that it'd be a PITA to grind these buds, so... "The More You Know TM".:doh:

Anyway, I'm a noob to concentrates that aren't already in a vape cartridge, so what's the best way to vape this?

I've placed tiny patties of the stuff on top of herb when I use my Anvil or Dynavap, but I'm not sure if that's the most efficient way to get it in me.

I do have an iSpire Wand, so I technically have the banger that came with it available to use (though I've never used it yet); would that be a better way of consuming this stuff?

Thanks,
 

Shit Snacks

Milaana. Lana. LANA. LANAAAA! (TM2/TP80/BAK/FW9)
This might've already been covered, but there are too many pages in this thread...

I got some moon rocks last week, and there was a lump of concentrate on the outside of a bud, so I peeled it off (not sure what type; it was dense and tar-like in consistency, but not terribly sticky).

This was also when I realized that it'd be a PITA to grind these buds, so... "The More You Know TM".:doh:

Anyway, I'm a noob to concentrates that aren't already in a vape cartridge, so what's the best way to vape this?

I've placed tiny patties of the stuff on top of herb when I use my Anvil or Dynavap, but I'm not sure if that's the most efficient way to get it in me.

I do have an iSpire Wand, so I technically have the banger that came with it available to use (though I've never used it yet); would that be a better way of consuming this stuff?

Thanks,

You can't use it in a banger, since it's a bud with hash and oil, yeah you'd need to smoke it or use a vape, but it's really tricky to find a vape that can actually use it... I tried them in BAK and they sucked, at least the quality probably of what I had, but that vape can use them so I don't know what else you have that could do it well though, maybe Anvil or DV
 
Shit Snacks,
  • Like
Reactions: Vitolo

bulllee

Agent Provocateur
This might've already been covered, but there are too many pages in this thread...

I got some moon rocks last week, and there was a lump of concentrate on the outside of a bud, so I peeled it off (not sure what type; it was dense and tar-like in consistency, but not terribly sticky).

This was also when I realized that it'd be a PITA to grind these buds, so... "The More You Know TM".:doh:

Anyway, I'm a noob to concentrates that aren't already in a vape cartridge, so what's the best way to vape this?

I've placed tiny patties of the stuff on top of herb when I use my Anvil or Dynavap, but I'm not sure if that's the most efficient way to get it in me.

I do have an iSpire Wand, so I technically have the banger that came with it available to use (though I've never used it yet); would that be a better way of consuming this stuff?

Thanks,
Use a razor blade to shave off slivers , just like some good hashish. I sandwich some using cotton in a Dynavap with good results :tup:.
 
Top Bottom