Polyphone
Active Member
Thanks for the clarification. I assumed this meant o-ring but want sure.Thanks for the photo! Yea I meant an o-ring. When I first did it way back, I used a thin strip I sliced off of the end of a bit silicon tubing that I recieved with my first (or second?) Mi. Same as an o-ring just not an o-ring per se. At the time, I considered the load to be too close to the heater so a ring of the tubing around the stem allowed me to raise the position of the load relative to the heater![]()
How do you all go about cleaning these things fresh from the workshop?