I use the stems and caps that Ddave sells for the EQ- the caps fit on the milaana stems. I don't understand why these are not selling better. The milaana is so much better than most vapes out there.
Honestly, for me, you did. I was so confused lol. I've read that like 6 times and my mind is still spinning about what's going on haha
Hahaha, oh! That's funny, my friend's is similar. He takes his out and it looks like he's got a Walnut Milaana because it's so dark (I was going to make a joke about how I can't wait until different wood Walnuts come out but that day is already here
)Thanks man! That would be my backyard! And you're right, it is a very nice destination for a Milaana sesh. Thankfully it's only a few steps away! Unfortunately, the mosquitos claim that land as their own. But winter is starting...so run little guys...run.I like your cloud chasing videos @AJSKeep it up! Where you at in the video before the last one? Looks like a nice destination for a Milaana sesh
Use light sandpaper, 320 grit, it will get all the dirt out, as well as smooth the wood. I've been using Walnut oil, had good luck heating wood with a heat gun (blowdryer works) just prior to applying sealer.
looks very nice.
Where did you get the oil?
Got some wooden stems from @Alan and was thinking about picking up some of the butter wax but may look into that as well.
edit: is it also not too much of a worry to have some plant particulate stuck in the little groove where the glass meets the heater? Blowing won't work and I don't wanna poke around and damage something... especially if it's nothing to worry about
Walnut oil I got on Amazon, but the stain I made from coffee and vinegar. I boiled coffee down to a thick liquid, added some vinegar, sanded a few times, then applied multiple walnut coats, sanding to 320 at every step.Where did you get the oil?
Got some wooden stems from @Alan and was thinking about picking up some of the butter wax but may look into that as well.
edit: is it also not too much of a worry to have some plant particulate stuck in the little groove where the glass meets the heater? Blowing won't work and I don't wanna poke around and damage something... especially if it's nothing to worry about
Further back in this thread someone showed how to fix that, drop a bent paperclip down in the battery compartment and lift the tab slightly. Maybe someone can give thanks to whoever that was as my memory isn't that good
Common problem but pretty easy to fix. The clip is attached on one side only. That is the side you need to pry, pull up a hair. You can use some kind of hook to get under and lift with steady, but somewhat firm pressure. It only needs to move a hair, so err in the safe side, and try again. Ive also had good luck using a long narrow suture clamp that I used to use as a roach clip.
Mi is my only vape atm so no other accessories but it doesn't seem to be an issueAnother easy way to pull up the negative tab is to get a long nylon brush (everyone has them I have a ton) that comes with most vapes and use the loop on the handle to snag the negative terminal and pull up very gently holding the bristled end of the brush.
If ya got a short brush use needle nose pliers to hold the bristled end so you can stick the loop down under the tab.
I just fixed my buddies last night this way.
Wow thanks man! HahaOh man you are a legend! I think I would be like perma stoned after all that at once...
And gotta get me one of those bubblers its exactly what I've been looking for what is it? d-020 or something?
And also at the end.... Fucking BI MI operation
Now I want another Mi just so I can give that a go
Visit a glass studio or headshop with glass blowing on site to help cut down your green stem.
