Hi, try to use the low white setting with SMALL amounts (like a half/full rice grain sized dab), it's like I use it and it works for most concentrates although some crumbles need higher temp. Yes the donut turning black is normal but doesn't affect the taste if you use q-tips after each dab although... Let me know if that helps. By the way electricals devices and water are never going great together, be sure no water reaches the connector.Yo I got a little water where the coil screws in and it wouldn't heat before I cleaned the water out, now it works fine but seems to be heating really hot, the flavor seems off burnt I think. Its not the coil because I also tried my backup coil. Anyone have some advice?
Also both ceramic coils I bought started to char and turn black after the first couple uses, I always clean and low temp. Help
To get big cloudage the loading size is preponderant, big load doesn't release as much vapor as a smaller dab does. Please experiment with smaller loads and stick with low setting if you are a flavor chaser.Got the green edition qomo yesterday tried some rosin and live resin in it, seems pretty decent but even smaller then expected dang that’s rig holds like 5 droplets of water max lol. Haven’t really gotten the big results I’ve seen some people post but I have a feeling those shots were on max temp ceramic. Testing with a terpometer is interesting it’s showing randomly some super high temps but I haven’t had burning issues in use yet. Will report back later when I have some more rounds with it so far it’s a fun piece though. My green is quartz only no ceramic for me.
Me too, dry use mainly except when used with a larger bubbler. Thank you for sharing your Qomo's usage tips!I use it DRY. Personally, I don’t find the small amount of water it holds, doing any real cooling.
Yes it's an accessorie I suggested to release although it was different than your in my mind: I thought about a bottom less banger which would replace the glass housing, with a classic spherical carb cap and a stopper to clogg the Qomo's bubbler vaporpath (cause the vapor will follow the bottomless banger direct vaporpath to your own big bubbler/recycler). Which solution do you think to be better G&G? I think mine is better cause the vapor will not touch anymore the silicone in the device cause the vapor will not travel anymore through the device but only through the glass setup, let me know...I came up with an adaptor plan, I’ll see how viable it is in the next while but so far seems decent. 14m/18m adaptor in the qomo, 14f/18m adaptor with orings in a bottomless banger for the rig with a marble sealing the top. Obviously a u-shaped 14m/18m would be ideal xmax should release one sometime as well as slightly larger glass piece imo but so far the little dude is pretty fun. Not getting huge results but also not disappointed yet. Edit: adaptor works perfect with the rig set at the right height but would be a bit tricky if trying to hold this in hand while hitting vs being on a table. Also to add I don’t like the cap/tool combo, if it was simple a spinner style air channel without trying to be the tool to I think it would help keep the oil moving slightly inside.
Last edited: