Upgrading from Fury Edge to Mighty. Anything I need to know?

[iammyself]

I don't know if this is the problem you are experiencing but I noticed that when you take apart the mouthpiece there's this tiny hole in the middle where the vapor travels through. While cleaning the inside of gunk I noticed this didn't help the airflow. When I cleaned this small space in the middle (above the screen) it helped alot. Maybe something is in there?
Did you switch out the stock screen in the mouthpiece for a finer one?

Yes, I did. I didn’t see anything obstructing it. The new mouthpiece is a bit more restricted than the old one, even with reclaim building up in the old one. Probably tighter seals in the new one.

 

[justcametomind]

imho you should check every gasket is placed correctly. They can get dislodged when you assemble the CU. I followed Mighty thread for a long time, and periodically users experienced what you are too. That, or resin blocking the airpath. I'd ISO bath everything on the CU (gasket only a couple of minutes), and then check the airflow, piece by piece (I mean expecially the moutpiece) and then after the assembly is done.

 

[iammyself]

imho you should check every gasket is placed correctly. They can get dislodged when you assemble the CU. I followed Mighty thread for a long time, and periodically users experienced what you are too. That, or resin blocking the airpath. I'd ISO bath everything on the CU (gasket only a couple of minutes), and then check the airflow, piece by piece (I mean expecially the moutpiece) and then after the assembly is done.

Yep, the top, small gasket was a bit askew. That, plus the low producing flower, were the problem. Working great again. Thanks.