finally got a Tinymight today! unfortunately I can’t get it to heat up. I’m not even sure it’s turning on/off properly.
when I triple click, it flashes green then red vibrates 3 times. Then it vibrates and the red light comes on for about 2 seconds. I then press button it vibrates once then nothing happens. fully charged battery. I looked at heater while trying as well and I don’t see it glowing. Tried this at all temps. Also tried session mode, but it acts the same way. Every time I hit the button it vibrates. Every triple clicks responds the same way.
I tried searching for this problem with no luck. Anyhelp greatly appreciated I’m eager to get this TM working
Thanks for the quick reply. I tried a different battery and it works. I was so embarrassed I tried to quickly edit the post but your too fast ss!That sucks I'm sorry, no help other than sounds like an unfortunate warranty problem, and just to add the heater should never glow btw just the red light when on
Thanks for the quick reply. I tried a different battery and it works. I was so embarrassed I tried to quickly edit the post but your too fast ss!
I got for some time a Molicel P28a. TM vibrates 3 times like its empty but when I eject it and put it in the battery charger it always shows 2 bars out of 4, like its not really empty. This is not happening with the Samsung battery that came with.
I got for some time a Molicel P28a. TM vibrates 3 times like its empty but when I eject it and put it in the battery charger it always shows 2 bars out of 4, like its not really empty. This is not happening with the Samsung battery that came with.
@Ed's TnT makes a lovely 14mm wood 14mm WPA. I use that one exclusively. It's fantastic.Somewhere in this thread I saw – or think I saw – a source for a 14mm WPA (not the 10,14,18 combo that TM sells). I'd love to find one.
As far as the variability of vapor production goes, I'm consuming recently-cured weed, and the moisture level is a bit higher than usual. Sometimes I find that I run out of lung capacity before vaporization happens. If I notice this I use a different inhalation technique. I keep the tube in my mouth the whole time, inhale for a bit and then exhale through my nose, then repeat the process. Usually by the third exhalation vapor production begins and I can see vapor when I exhale through my nose. I started using this technique on my FlowerPot. The TM is the only portable I have that has enough heating capacity and sufficient airflow to allow this technique.
Maybe you needed the third doseWell I kept up my end of the bargain and sold the tennis shoes... but couldn’t get my order to go through last night!
Farewell, cruel world!
Wow. I ordered these yesterday and I just got notification they are out for delivery. Amazon is wild...Now THAT is reasonable. Even for 10 but 38 more for another 2 bucks is cheap. Same size as the rubies I have as terp pearls but this is meant to fill a stem. I may try some as terp pearls as well.
Are the 6mm too big for stem fillers? Incidentally, I realized that the ball bearings are probably not a good idea due to potential rust...
Man I don’t need to see these kinds of posts. I’ve been holding the line on the TM, quite heroically I would say. Something happened recently that caused me to falter… at this point resisting this purchase only through sheer tyranny of will
I think VAS is for life. It can go into remission, but it’s bound to pop back up at some point
Somewhere in this thread I saw – or think I saw – a source for a 14mm WPA (not the 10,14,18 combo that TM sells). I'd love to find one..
Wow. I ordered these yesterday and I just got notification they are out for delivery. Amazon is wild...
It’s called VAS-19 and there is no cure. I’ve been infected for 18+ months and have loved my TM every minute of that time. Seriously though the TM is an awesome, powerful, easy to use, flexible vape - something for everyone. Let your mask down for this oneI think VAS is for life. It can go into remission, but it’s bound to pop back up at some point
Would have been nice if they used less packaging. 8 X 10 blue and white mailer for a 2" X 3" package. A shame. 70 or 80% of my recycling is Amazon packaging. And DHGate I guess...Haha still so impressed by the boon that is prime one day shipping??
VAS is not about what you need. It's about what you WANT. And I don't think it ever goes away. I've been "satisfied" a bunch of times and it never stopped me from buying new shit. I'm fully satisfied right now, but I am waiting patiently for the release of Revolve...Hopefully having one of the best devices will cure VAS, because this is my fourth vape even though I'm fairly happy with the first three!
cyberguy, I agree completely about want versus need, but the TM seems to tick every box of my wants. I don't want this to be the start of a collection -- I want something that tastes good, is easy to clean and won't become a brick when the battery eventually dies. Fingers crossed that I can get it and this will be the one!
NOOOO!Is it still VAS if one is buying a backup or replacement for a broken vape?