Discontinued The Persei Vaporizer for herbs and concentrates.

THC SCIENTIFIC

To Boldly Go Where No One Has Gone Before
Manufacturer
Should we carry these?


DSC_0234.jpg
 

Porquiplane

Look Into My Eyes
Like, but maybe colours as well? A coloured tube and/or cap. For organization its nice to know which tube is what cartridge.
 
Porquiplane,

Bob Loblaw

Astralnaut
Like, but maybe colours as well? A coloured tube and/or cap. For organization its nice to know which tube is what cartridge.
colored dot stickers for tops from any craft or office supply store would probably work. i like this. perfect size, other than round bottom, i'd just put in upside down
 

DubCRider

Well-Known Member
Just write your favorite concentrate names on each tube and keep filling that cart. It may not be the exact wax each time but you will have your strains right.
 

ilovedoobies!

Active Member
Yes seems like that would work for keeping lint and what not off the bottom and mouth piece of the carts :rockon:
 
ilovedoobies!,

bluesurfboy

Member
Use the tool to run the plate up until it's snug against the battery above it, then back it off 1.5 turns. This setting should work fine.

They are charged, right?

OF

They are charged. I seriously turned until it was physically unable to turn anymore (I went until i worried about the batteries endcaps bending due to pressure)

...I noticed the IMRs dont have the protruding nipple (+) , that the normal store-bought batteries have. SO i figured i would just need to apply extra force for the metal contacts between the two batteries to meet. I have no doubt both the negative end of the bottom battery is touching the spring and the positive end of the top battery is touching the nipple from the top. (single/or dual tops both tested not working)

It seems the design is poor as the red plastic seems to keep the metal from being able to properly contact eachother.

Are they charged? Does it say AW on it? Where did you buy it from?

They were the batteries you sent me because the trustfires that came with my unit were bunk, but now i am not so sure it is just the batteries.

I had issues with my PErsei batteries that came with it, my 7.4 v set up was bruning carts out in a day (never got a cart to last longer than 1.5 days with medium-light usage) and on the 3.7v set up, my first 1.5 worked decent for the first few rips but then immediately after setting it down for my first sessions, posting of how well it worked, i ran into all my problems, realizing this device is more hassle than its worth. too many issues, not adequate on-site customer support representative/center. (shipping took almost a whole week to receive.

I am beginning to think it is not my batteries but the top as even the new 3.7 v battery performing like others have stated. It seems something in my unit is causing my batteries to burn out entirely too quickly, maybe a short or drain somewhere?

I am getting frustrated as i have never spent so much on concentrates since getting this device, and much of it is unreclaimable/unenjoyable from the carts after they are no longer working.
 
bluesurfboy,

THC SCIENTIFIC

To Boldly Go Where No One Has Gone Before
Manufacturer
They are charged. I seriously turned until it was physically unable to turn anymore (I went until i worried about the batteries endcaps bending due to pressure)

...I noticed the IMRs dont have the protruding nipple (+) , that the normal store-bought batteries have. SO i figured i would just need to apply extra force for the metal contacts between the two batteries to meet. I have no doubt both the negative end of the bottom battery is touching the spring and the positive end of the top battery is touching the nipple from the top. (single/or dual tops both tested not working)

It seems the design is poor as the red plastic seems to keep the metal from being able to properly contact eachother.



They were the batteries you sent me because the trustfires that came with my unit were bunk, but now i am not so sure it is just the batteries.

I had issues with my PErsei batteries that came with it, my 7.4 v set up was bruning carts out in a day (never got a cart to last longer than 1.5 days with medium-light usage) and on the 3.7v set up, my first 1.5 worked decent for the first few rips but then immediately after setting it down for my first sessions, posting of how well it worked, i ran into all my problems, realizing this device is more hassle than its worth. too many issues, not adequate on-site customer support representative/center. (shipping took almost a whole week to receive.

I am beginning to think it is not my batteries but the top as even the new 3.7 v battery performing like others have stated. It seems something in my unit is causing my batteries to burn out entirely too quickly, maybe a short or drain somewhere?

I am getting frustrated as i have never spent so much on concentrates since getting this device, and much of it is unreclaimable/unenjoyable from the carts after they are no longer working.



Can you show me a pic of the batteries I think I may know what's going on.
 
THC SCIENTIFIC,

OF

Well-Known Member
Can you show me a pic of the batteries I think I may know what's going on.

You're smelling the same rat as I am? Flat top batteries got in there somehow? As I recall, guys use small plated rare earth magnets to correct this. Let me know if you need it, I'm sure I can dig up the link.

You're on top of this one G?

OF
 
OF,

THC SCIENTIFIC

To Boldly Go Where No One Has Gone Before
Manufacturer
You're smelling the same rat as I am? Flat top batteries got in there somehow? As I recall, guys use small plated rare earth magnets to correct this. Let me know if you need it, I'm sure I can dig up the link.

You're on top of this one G?

OF

Yup somehow flat top go in.
 
THC SCIENTIFIC,

THC SCIENTIFIC

To Boldly Go Where No One Has Gone Before
Manufacturer
That 'fits you real good' part has me a bit worried, too. Best outcome might be a cheap suit I'll never wear???

You know G though....you never know G.....

OF

Thats life brotha we will never know what will happen a second from now, but this will be with you for ever me guessing.
 
THC SCIENTIFIC,
  • Like
Reactions: Bob Loblaw

Limosnero

Active Member
So just to be clear the 18350 AW IMRs are best for "The Hammer" correct? Also, on the dube tube type cases...a flat top and bottom would be better IMO & still would love to see the Taser attachment :)
 

THC SCIENTIFIC

To Boldly Go Where No One Has Gone Before
Manufacturer
So just to be clear the 18350 AW IMRs are best for "The Hammer" correct? Also, on the dube tube type cases...a flat top and bottom would be better IMO & still would love to see the Taser attachment :)

Yes 18350 IMR is the battery to use with the Hammer.

Working on the flat top but i dont think its going to happen honestly we need to make new molding for that. This is off the shelf ready so you never know. If accounting ok's it then we will make it.
 
THC SCIENTIFIC,
Hey g, I was wondering if there might be a possibility to have a "shorty" setup like the omicron v2? I really would like to have a single battery 1.5 setup with a little more discretion :-) again thanks for all your efforts, big ups!
 
Luckysglass,
Top Bottom