Anybody wanting to remove their bowl screen in a "+" model by deforming it like on the old ones, be careful,
Or don't do it at all.
(On the first Crafty+ models anyway for sure) It's now supported by four feet across a much wider area instead of a small central post so you might do damage if you don't work very carefully.
Personally I wouldn't try it again unless really needed.
Troy & Jerry have found some “interesting things” regarding the Crafty+ and Mighty+ & will go into detail in next week’s stream. They recommend to wait before buying until you hear what they have to say. Convo starts at 4:07 in this vid.
Some other guesses from me about these interesting things:
I found the new Crafty+C manual and it says charging is not possible during use, or don't use while charging.
So on that model they've dropped a less than ideal pass through charging system (which I would never use anyway), for no pass through at all.
Also, when I calculate what they are doing with the Mighty+ USB-C Supercharger plug, there's a slight possibility in my mind that the device might charge a bit slower while using the device to vape (pass through charging). But it should be a true pass through system which is not hard on the battery and continuously charges in use.
And, that without the USB-C Supercharger, which is not included, no pass through is possible and even just charging alone may take place very slowly if using any old 1 or 2 amp USB A charging plug that you may have lying around.
Maybe also that the vapor is in their opinion, similar, not much stronger, or has a harsher edge to the taste near the end like the Crafty+ might have also had, and they feel they slightly prefer the taste of the old one?
Then the fact that some aftermarket stands will still fit, but on some it blocks out the USB-C port.
I don't need it to stand at all and would prefer it without any legs!
Almost broke down and ordered one last night, I might not make it through tonight!
(Things have been tough lately, think I need to treat myself)
