vapirtoo
Well-Known Member
Hey JD and NOOnan
My PA also ran cool and the tighten the button fix did the job.
At first I made it too tight and- as Noonan pointed out- the damn thing
got stuck in the on position, so I had to back it off a bit to loosen it up
again. It's now back to normal.
I had the chance to visit another MFLB friend and I brought over the PA.
I was using the same 80% setting that I always used, but on his box
this proved way too hot. I was too nice to let it combust, and had to
pull on the stem very hard to bring temps back . I almost switched boxes
on him 'cause I liked the way that shit heated up. I now see that different
boxes run differently. Way back in this thread, around Sept., a poster
derided our box saying it was impossible not to combust with it. I now
see how a noobie could have this happen.
My PA also ran cool and the tighten the button fix did the job.
At first I made it too tight and- as Noonan pointed out- the damn thing
got stuck in the on position, so I had to back it off a bit to loosen it up
again. It's now back to normal.
I had the chance to visit another MFLB friend and I brought over the PA.
I was using the same 80% setting that I always used, but on his box
this proved way too hot. I was too nice to let it combust, and had to
pull on the stem very hard to bring temps back . I almost switched boxes
on him 'cause I liked the way that shit heated up. I now see that different
boxes run differently. Way back in this thread, around Sept., a poster
derided our box saying it was impossible not to combust with it. I now
see how a noobie could have this happen.