Gatsby T Pig

Well-Known Member
I just oredered my MFLB! I am very excited and think I got a great deal form puffitup.com. I got 15% off and a free 4 piece grinder with it.
 
Gatsby T Pig,

TuffGong

YOUR AD HERE! CALL NOW!
anarki66 said:
as anyone tried vaping hash in a MFLB? will it effectthe unit in any way?
It is not recommended to vape hash or oil in the MFLB. It apparently plugs the screen. Someone here tried it and damn near killed the little guy. :/
 
TuffGong,

VivaSativa

Well-Known Member
anarki66 said:
as anyone tried vaping hash in a MFLB? will it effectthe unit in any way?
It works fine and I'm doing it as we speak, infact :brow:
You just have to be absolutely sure that your hash will not melt, and I think it'll be safe. I felt confident that my hash doesn't melt after smoking a bong hit of sprinkled hash over a metal screen. I held flame for a good 10 seconds on it and it burnt but just turned into ashy gray.
Here are some tips for vaping hash in the LB:
Do this at your own risk. Magic Flight advise against it.
In my experience (with only one type of hash that I got, don't have other hashes to try), it takes a bit longer to get good vapor from a hash hit, and you'll need strong fresh batteries and to inhale very slowly to maximize the heating.
The LB gives best results when the material is ground up to a fine powder, and with hash it's no differnet. You can put in a small chunk of hash (even rock hard hash) and take a few hits from the LB, and then you can crumble the warm and soft hash to smaller pieces and sticky powder.. Make sure it doesn't clump up and stick to the trench, use the iron top of the supplied brush to very gently scrape it off if it does. In the first few hits it looks like brown mush, but if you take a short break and let it cool off a bit, you can then crumble it to a little finer and drier powder.
Warm hash tends to clump together more than weed, so you should make sure that when you're shaking between hits, the hash doesn't stick to the trench, but shakes around. There might be powedery pieces that get stuck to the shoulders of the trench, brush them in.
It's harder to know when the trench is spent than with weed, and I still don't really know, I just stop when I don't like the taste anymore. It's dusty black at that point.

I think that if you keep your box clean then there's no risk in vaping non-melt hash, but again, do this at your own risk :peace:

And here's a very blurry cell cam pic of my LB, half trench with hash and half without so you can see the blurry bottom.
hashlb.jpg
 
VivaSativa,

DeepFried

A Legend in my Own Mind
steven22 said:
Hey guys, my LB just arrived today

I like the size and everything, and it works, im very lit off one bowl... I am also an Extreme user that needed something portable...

.. I cant seem to get my herb the light to medium brown evenly the way my extreme does, with the LB the herbs are either really dark brown almost black or still green... the herbs that make contact with the screen of the trench turn dark, it isnt uniform or even... and I shake after each hit real well...

i grind mine to the constancy that my chromium crusher 4pc would grind it to.
Try grinding up side down so that the herb gets ground to a much finer consistency. The holes in the chromium crusher are far too large for the grind size that works best in the LB.
 
DeepFried,

chucku

Charles Urbane
TuffGong said:
anarki66 said:
as anyone tried vaping hash in a MFLB? will it effectthe unit in any way?
It is not recommended to vape hash or oil in the MFLB. It apparently plugs the screen. Someone here tried it and damn near killed the little guy. :/
I put a thin bead of kief in the bottom of the trench and it works great.
 
chucku,

B.

War Criminal
LB with short stem + Myrtle Zap stem + 14.4 GonG = LB bong rips!

I can't believe I haven't done this yet. I just realized the short peg fits perfectly into my MZ stem, which makes a very nice seal with my 14.4 bong, and if ya kinda tilt it a little, big bong hits!
 
B.,

BillySnarf

Well-Known Member
Howie Feltersnatch said:
Gatsby T Pig said:
I just oredered my MFLB! I am very excited and think I got a great deal form puffitup.com. I got 15% off and a free 4 piece grinder with it.
What code did you use for the 15% and did they ship it free?

Modnote. Please stay on topic. Discounts can be found in the retailer thread. http://www.fuckcombustion.com/viewtopic.php?id=2463
I just got mine a couple days ago from here.. Use code FC-1... free shipping, 15% off, and 4 piece grinder.

Edited b/c I screwed up the code. it is correct now
 
BillySnarf,

GreenLeaf

Well-Known Member
For those of you who fill just the bottom of the trench up with a tiny amount of ground up powdered herb, do you just vape it all in a hit or two and then take it out if you save it to cook with?

Or do you get another vape hit from that and then take it out to save it for cooking?
 
GreenLeaf,

MikRoOrganix

Erlhead!
I use keif in mine all the time - kif that doesn't melt. A little sprinkle really makes the first few hits stronger. Sometimes it sticks to the trench, so shake it up or use the brush to dislodge.

I would absolutly save MFLB avb. I am vaping some right now in my HerbalAire. First there is the fact that (for me) some of the mflb abv is dark, and some is still green. This tells me that the extraction was imcomplete even at low temps. I just blew a bag at 330f that is moderatly thick. Then there is the extraction effeciency. I am able to blow 5 bags!!! With ABV! (one at 330, one at 340, then 355, and 375. I blew a final bag at 400 but it was a bit thin. I try to extract as much as possible below 400 for better taste)

If you are interested in stealth they will make custom-lidded units in opaque or black if you email them :)
 
MikRoOrganix,

tdavie

Unconscious Objector
I'm saving up my ABV (half goes to g/f and half goes to a brownie bucket).

I'm not going to revape my MFLB ABV in another vaporizer (tried that before in the Extreme .v3 and it tasted pretty bad in my opinion); I'm going to use it for Cannabutter -> peanut butter cookies. I used 21g unvaped bud (don't know what kind) to make 44 cookies, and each of those were very effective; a heavy body load, all pain gone and they cause me to stare at my aquarium for long periods of time. So I figure I'll use about 60g of ABV for the same 44 cookies (70% from MFLB and rest from Extreme/Iolite).

Tom
 
tdavie,

DeepFried

A Legend in my Own Mind
MikRoOrganix said:
I use keif in mine all the time - kif that doesn't melt. A little sprinkle really makes the first few hits stronger. Sometimes it sticks to the trench, so shake it up or use the brush to dislodge.

I would absolutly save MFLB avb. I am vaping some right now in my HerbalAire. First there is the fact that (for me) some of the mflb abv is dark, and some is still green. This tells me that the extraction was imcomplete even at low temps. I just blew a bag at 330f that is moderatly thick. Then there is the extraction effeciency. I am able to blow 5 bags!!! With ABV! (one at 330, one at 340, then 355, and 375. I blew a final bag at 400 but it was a bit thin. I try to extract as much as possible below 400 for better taste)

If you are interested in stealth they will make custom-lidded units in opaque or black if you email them :)
If you were grinding your herb to the correct consistency you would not be able to properly use it in the HA. That is why you have green and black ABV from the LB, try grinding it finer.
 
DeepFried,

P0KERF1SH

Well-Known Member
I'm in for one and waiting oh so patiently... yeah right

Thanks to all for all the advice/info on the LB and batteries/chargers.
 
P0KERF1SH,

GreenLeaf

Well-Known Member
Anyone have any advice, tips, or personal techniques on using the MF LB?

Or how to get the most out of your batteries?

What works for myself is using a tiny bit of finely ground herb on the bottom of the trench and vaping it all in one or two hits.

I don't shake the box or tap it as I do not put lots of plant material in there and if I do need to move it around or clean out the trench I just use the brush.

I do not use the plastic tube that came with the vaporizer but if it fits a waterpipe bowl I have I will.

The launch box kit I got came with battery covers so I keep one of those on the Pozitive end of the battery when it's not in use.

Here's a question for magic flight and heavy/frequent users:

Does vaping produce residue at all like combustion does? Does the Magic Flight box have to be cleaned at all?

I remember when I first got the box I opened up the lid and put the battery in for a second to see if everything worked right and it did.

Would doing this with an empty trench and opening up the lid clean out any residue or leftover material that the brush can't get in the screen?

I have never ever combusted herb in the box but for those of you who have do you actually have to really intentionally try to do this and leave the battery in for a very long time say like minutes instead of seconds when the vapor first appears?

Modnote: Almost all of these things have been discussed in detail in this thread.

forum rules said:
Read threads before posting in them.
 
GreenLeaf,
I have to side with the mods on this.

If you sit down and read through this whole thread, you will find all these answers and much more. If you set your preferences to show 100 posts per page it makes it more manageable (IMHO).
 
Howie Feltersnatch,

Lean

Well-Known Member
I loved my MFLB, just sold it though, I needed something portable, but not that portable, plus I get bigger hits out of my VG.

I can easily say the MF is the BEST portable vape out right now. Without a doubt.
 
Lean,

smartfast

Well-Known Member
Hello MagicFlight,

Can you tell us how much resistance in Ohms the heating element should be?

The reason I ask-- my box has recently (and seemingly instantly) stopped performing as well as I remember it used to. I have brand new batteries and a top of the line Maha charger on the way... but while im waiting on those to arrive I was hoping I could troubleshoot the launchbox itself. I imagine it should be within a certain resistance range. I can provide my box number if it helps get that specification from you.

Obviously, since I cannot remove the screen .. I dont think there is any other troubleshooting I can do, correct?

Thanks,

A Happy Magic-Flier!
 
smartfast,

AgentofChaos

Serial Vapist
Anyone use their LB while driving? My Iolite is a great driving companion but I am interested in buying an LB as well...
 
AgentofChaos,

smartfast

Well-Known Member
yes, I have used it while driving. Its the smallest vape I know. The battery does stick out of my hand a little, so it is obvious im holding some "weird" up to my face, but otherwise it works great. The only (minor) downside is that you will sit there for 20-40 seconds slowly toking on it. If you drive a stick-shift, you have to develop your knee driving skills. If you share the road with nosy people, you may get some looks.

I like telling my friends/aquanitces that it is my medical inhaler, (referencing asthma inhalers)
 
smartfast,

Gatsby T Pig

Well-Known Member
I got my MFLB yesterday! Whoop-de-whoop! I haven't opened the box yet though. I am waiting to get my MMJ license and then it is straight to vaping. As promised, I will never smoke weed again.
 
Gatsby T Pig,

smartfast

Well-Known Member
Also, I wanted to tell the thread this .. if you want to search this thread (or any thread) for all occurrences of a term .. do this:

1) Use the Firefox Browser
2) Download the "repagination" add-on for firefox from here (the link is "my hack")
3) log into Fuckcombustion, go to the first page of this thread, right click the page "2" link and choose Re-paginate > All
4) Go grab a beer or make yourself some tea. Come back in 4 minutes and the ENTIRE thread will be loaded into your browser. Simply scroll down to read the whole thing.
5) Bonus and main point of doing this: You can use the browsers find function (ctrl + F) to find all the occurrence of a term in this thread. VERY helpful for doing research

another edit: it makes the waiting faster if you edit your forum preferences and allow the maximum amount of posts per page, 75
 
smartfast,

GreenLeaf

Well-Known Member
smartfast said:
Also, I wanted to tell the thread this .. if you want to search this thread (or any thread) for all occurrences of a term .. do this:

1) Use the Firefox Browser
2) Download the "repagination" add-on for firefox from here (the link is "my hack")
3) log into Fuckcombustion, go to the first page of this thread, right click the page "2" link and choose Re-paginate > All
4) Go grab a beer or make yourself some tea. Come back in 4 minutes and the ENTIRE thread will be loaded into your browser. Simply scroll down to read the whole thing.
5) Bonus and main point of doing this: You can use the browsers find function (ctrl + F) to find all the occurrence of a term in this thread. VERY helpful for doing research
Thanks for the advice. I'll do this :)
 
GreenLeaf,

TuffGong

YOUR AD HERE! CALL NOW!
Hi all. I received my LB today... nice. I can't see it ever replacing my Buddha, but it seems to just what I need for travel. :D

I did not however get the Sanyo charger & batteries. I get a Chinese no name charger, and peeled batteries, so I have no idea what they are. I thought that the Sanyos were the standard set currently. For recent owners of the LB, what did you get for a charger & batteries? By the way, my box number is well over 344,000.
 
TuffGong,

the ob

all good in the hood.
where did you order from ^^ I ordered a week ago and got the sanyo charger and mine is in the 320,000 range.
 
the ob,
Top Bottom