Frederick McGuire
Aggressively Loungey
I just found a new way to vape with this lovely device.
Basically, I have been having a fair bit of particulate get past the screen in my WPA, and my bongs were getting dirty (enough to require a good cleaning to get all the little chunks of weed out) after 3-4 loads.
The other week I picked up my first properly high quality glass piece (I actually picked up a möbius reti Bub and a LW 15 arm on the same day ) and I didn't want them getting dirty so quickly.
Since my WPA is a 14mm, and my new glass is 18mm, I knew I'd need to use a reducing adapter.
I grabbed a screen I had for putting into the stem of my solo, and managed to get it to sit very stably in the bottom of the reducer.
Voila!
no more weed gunking up my glass.
That would have been the end of the matter, but after a few loads, I wanted to see how much particles i had stopped.
While not much in overall, it's definitely nice to have stopped it from going into the bong.
Anyway, I had an idea; this stuff should essentially be wand hash, not ABV, but there wasn't enough to put Ito the WPA for a proper load, so I just put my LSV against the top of the reducer, started pulling, and got a nice hit out of it.
It's not 100% air tight, but the leak is negligible.
I haven't tried it with fresh herb yet, but it's nice to get a freebie hit every 2nd load or so.
Basically, I have been having a fair bit of particulate get past the screen in my WPA, and my bongs were getting dirty (enough to require a good cleaning to get all the little chunks of weed out) after 3-4 loads.
The other week I picked up my first properly high quality glass piece (I actually picked up a möbius reti Bub and a LW 15 arm on the same day ) and I didn't want them getting dirty so quickly.
Since my WPA is a 14mm, and my new glass is 18mm, I knew I'd need to use a reducing adapter.
I grabbed a screen I had for putting into the stem of my solo, and managed to get it to sit very stably in the bottom of the reducer.
Voila!
no more weed gunking up my glass.
That would have been the end of the matter, but after a few loads, I wanted to see how much particles i had stopped.
While not much in overall, it's definitely nice to have stopped it from going into the bong.
Anyway, I had an idea; this stuff should essentially be wand hash, not ABV, but there wasn't enough to put Ito the WPA for a proper load, so I just put my LSV against the top of the reducer, started pulling, and got a nice hit out of it.
It's not 100% air tight, but the leak is negligible.
I haven't tried it with fresh herb yet, but it's nice to get a freebie hit every 2nd load or so.