First off, I don't use the Arizer screens with the LSV. I tried it, but it doesn't work well with small loads.
Here's what I do. When I use the transfer wand, I fill the bowl (in the transfer wand) 1/4 of an inch full (from the bottom of the screen). I set my temp dial to 1:00. I use the LSV inverted so no bud touches the screen in the heater cover. For my hit, I puff on the wand as I would a cigar. I continue this until I feel a bit of lung expansion. I'll stop and pull the transfer wand out of the LSV and set it down. I'll hold that hit for about 10 seconds, exhale just a little bit and then re-inhale, hold of 10 seconds, exhale a little bit and then re-enhale. I'll do that about 4 times per hit.
With a fresh load and VERY good bud, I'll take two hits this way stirring bowl between hits. This is all I need with possibly one maintenance hit from either my MFLB or FlashVape) The bowl is obviously not done as it is still a very light brown with some green left so I'll empty out the bowl into a small Space Case airtight container to save for the next evenings session.
The next evening, I'll do the exactly the same thing, but being that the bud has been partially vaped, I'll take 3 hits using the same technique as above. When I'm done, I'll save what is left for the 3rd nights session. On the third night, I'll take two hits and then I'll empty the bowl into the palm of my hand, crumble between fingers and reload for one final hit before it goes into my ABV bowl to be used for edibles.
Again, this is all from one quarter of an inch load into the transfer wand. The ABV, at this point, is a dark coffee brown.
When I use the WPA through water, the above techniques are exactly the same other than the "cigar puffing".
Hope this helps.
