-
SCAM WARNING! See how this scam works in Classifieds.
Dynavap VapCap
- Thread starter Fenton Mewley
- Start date
Cmdr. Redeye
Former Cylon sheriff
One thing I haven't seen addressed too much is degree of packing... One combo is a hard draw, still working on that. Stock M7 draws fine. Carbs or chiron inlets (!) vary but they should be about the same.
CR
CR
hotmeals
Serial vapist
Yoo, I just tried a BallR/M7 bowl with the Wand, that was amazing. Just have to make sure the click disc isn't in the coil, same as a normal cap. Heats up pretty fast and you can give the bowl section a little preheat if you're not using an insert.
Edit:
It's largely personal preference for Dynavaps with the standard caps, but there is a too tight IMO. I think they can handle quite dense packs, but it's good to try to make sure the pack density is even throughout the bowl. I used to pack them pretty densely, and using the straw or press/dip/scoop techniques would sometimes lead to a density gradient when trying to pack more densely. What I used to do was roll a little broken up herb into an evenly dense Dynavap cylinder shape and then insert it into the bowl lol. You can get some dense packs that still have good airflow and vape super evenly that way. These days I just scoop it into the bowl and do a looser pack.
Last edited:
Cmdr. Redeye
Former Cylon sheriff
Bonger x Ti bowl/tip x BallR works very well.... A good 18650 flashlight is a useful vapor-cloud density checker.
That tip was causing carb probs in both stems /XL mouthpieces. Unsure why.
CR
That tip was causing carb probs in both stems /XL mouthpieces. Unsure why. CR
WhyWhyWhy?
Active Member
It looks amazing! Is this a stainless steel Simrell collar?Having a good time with the Hyperdyn tip and cap. It really is what I keep reading: a bigger Dynavap experience.
Nebelmann
Well-Known Member
It is. Haven't used it without. Dark coffee roast with some seconds after the second click.
Grow Goddess
Just vaping
I am kind of new to DynaVap, here is my take. I am using the M7XL with the BallR Cap. For me, it is a complete game changer, and a daily use tool. However, I am not heating it like most people. I do not use a torch or an induction heater. I am using radiant heat from my ball vape rig. I made a stainless steel adapter and it works awesome!
I did open my cap, it was difficult the first time, but after it has been removed once, it is easy from there. I used the shank of a 25/64" drill bit, worked it back and forth until it popped off. I took out the metal balls and put in 2mm quartz beads. I did not like the way the quartz beads worked, most likely due to the way I am heating the unit. I put the metal balls back in.
Here are a couple of pictures of what I am working with. These images are shown with the M+, I have not tried that one yet.
Cmdr. Redeye
Former Cylon sheriff
Getting consistent good results with BallR, but with a broader yellow flame. My hands shake and that milimetric pinpoint aim line is optimistic.
That said, its heat curve is wonderful. I suppose it's convection/conduction but it's easy to work with. This particular cap clicks twice, usually.
CR
That said, its heat curve is wonderful. I suppose it's convection/conduction but it's easy to work with. This particular cap clicks twice, usually.
CR