On 12th April I watched a video on the ‘M’ & Pre-ordered from Vape Piranha UK.
On 14th April I discovered the Dynavap sale and ordered the Ti-Woody + spares.
Today they both Arrived!! I’ve already tried them both . .
Still playing around on how to use them. Only got single flames right now with a double on order. I’m sure I’ll eventually work out my preferred method, but I’m getting damn pretty high while experimenting.
My initial reactions are. . that I like blocking the carb with the 2nd O-ring, I prefer the Ti-Woody’s light weight body, & I much prefer the Ti-Tip.. . .
Some pictures (everyone likes pictures
) of my entry into Dynavaping. . alongside the home made dynastashes I made in preparation. . . . . . I’m a carpenter and I just knocked these up as an experiment last week while I consider what I actually want out of a dynastash. . . .
upload image gif
One question! Any one got any idea why my dynacaps only attract to the edges of my magnets and not the centre? Obviously I used the wrong type of magnet . . but I haven’t googled this as of yet . . .
I’m also going to mention that my Ti-Woody body had a bit of a serious problem on arrival. The opening at the collared end where the tip inserts was not big enough. I could barely force the tip into the body or pull it out, regardless of lubrication levels. Both required EXTREME force and getting it in was almost impossible. And honestly, the o-rings would not have lasted more than 2or3 assembly/disassembly with that level of stress and friction. . . .
So I had to roll up a small piece of 240grit sandpaper put it in a drill and use it to open & smooth out the hole. Took me ages, because I went SLOW not wanting to make it too big. . . . Now it slides in & out perfect. .
Thanks to all the contributors here. From Vapcap care to butane filtration I’ve learnt a lot!