LOL... good idea. I'll keep the kitty liter away.
Here is a post vape shot. I seldom vape to dark brown. I like to use my ABV for edibles and I prefer the taste from low temp terps so it's not very dark by my choice. The important thing is for it to be evenly cooked. I did notice a little smaller hit than ground pot. And, for some reason, the taste was not as good.
I'll try a few bowls and see how it goes. Overall, a nice result. If they just keep their size all night, might be a good idea. If these 'tabs' keep their shape all night, I am going to get a pill press and see how that works.
Someone a few pages back mentioned dosing caps for the VapCap. Someone else spoke about a pill maker, I believe. Overall, not bad ideas. This is what worked for me.
I took some pot and pressed it in a tube to make a rather stiff rod of pot the same (slightly smaller) diameter as the VapCap chamber. Then, I cut the 'snake' into small sections and put them in my little keychain carrier that I usually keep my Fury2 dosing caps in. Mine holds about 10 of these little 'tabs'.
The only issue I foresee if the potential that the 'tabs' will expand over the night and get too big to fit in the chamber. Or, just fall apart altogether in the carrier.
I'll make a 2" or 3" snake and cut it into tabs and see what happens tonight. I expect they will expand some but, hopefully not too much to fit in the chamber. I have a gig tonight so I'll be out all night with a crowd so it should make for a good test.
Not quite dosing caps but anything that makes it easier to load on the go is nice.
+1
+1
+1 again!
+1
+1
+1 again!
Super cheep mini hammer. Only glass I use anymore.
That hammer looks awesome! Where can I find one???+1
+1
+1 again!
Super cheep mini hammer. Only glass I use anymore.
Well, I have a NonaVong (with the carb-hole taped over) and it's milky hits every time. Otherwise, what @Skunkport said
EDIT : I don't think you need the 10 to 14mm adaptor - I think that's what the fat mouthpiece does, but don't quote me on this.
It takes a surprisingly small amount of water to cool vapor from the vapcap. I’ve used a silicone “blunt bubbler” that holds maybe a teaspoon of water, and works very well. Worth a try for less than $5 with free shippingI like the little bubbler in your first link at eBay. But...can you guys vouch for the fact that glass this tiny can actually ‘cool’ down the vapor from harsh flower?
Every inch between you and the vapor will help, but these go through water also, which makes a huge difference in my experience.I like the little bubbler in your first link at eBay. But...can you guys vouch for the fact that glass this tiny can actually ‘cool’ down the vapor from harsh flower?
the grain on that stem is incredible!Lacking a bit of wood porn over here.
14mm Bocote TiHE
