stark1

Lonesome Planet
You should AWAYS clean EVERY vaporizer before it's first use.

Always, always, always. No ifs, ands, or buts are applicable..


Or, you will turn into a horny toad. I toad you so.


vUV4dnw.jpg






Anyway, was so bummed out by my 41% failure at buying on the cheep 40%:20 sale, walla I distracted myself with a small gesture.

China spiral glassware—with air/H2O/glycerine cooling potential. A plus during
the fire burning daze of Summer.

Gonna be a blazin summer, folks!



mQwbGol.jpg
 

Squiby

Well-Known Member
Btw- do you clean the unit before first usage?
I would never put a new vaporizer in my mouth and inhale without it being cleaned first.

FIRST USE. Clean your Vapcap before using it to remove any machining residues. To clean your Vapcap before first use, disassemble it by first removing the cap and pulling the tip off the stem. Moisten a Q-Tip with your favorite cleaner and run it around both ends of the tip and through the condenser. Rinse with warm water and leave to dry completely before re-assembling.

those are some cute little critters-what do your cats have to say about them?
Well, they are VERY curious. They don't have any access to them but they know something new is here. Their main response is that they are more demanding of my time. They seem more attention from me and they have become more affectionate.

In short order though the Guineas will be bigger than them. I'm sure they'll be keeping their distance. Guineas travel in a cohesive pack. I think that they are the biker gangs of the fowl world.
 

Winegums

I make things from wood
Accessory Maker
Today I finished a long Vapcap stem for a custom order, the design is by @phattpiggie. There's a series of work in progress photos in my thread if anyone is interested. I'm super happy with the result.

yeOcyoN.jpg

There's a brass liner in the top that holds the tip and an integral SS condenser that runs the length of the stem.
 

KidFated.

Unknown Member

LesPlenty

Well-Known Member
Company Rep
Sure would love to get an 18mm/19mm wood stem for my VC
If you didn`t mind glass you could use an 18mm to 14mm male gong and stick the vapcap tip straight into the 14mm end, I did this with a 14mm to 14mm but I had to put a different o-ring on the start of the tip.
I removed original o-ring and stuck this;
Size: ID_4mm / OD_7mm https://www.ebay.com.au/itm/2-42MM-...var=552700309467&_trksid=p2060353.m2749.l2649

It is a great fit, does not fall off gong, even while holding at the end and jamming on my de- bowler.
Here is the gong I used

https://www.ebay.com.au/itm/14mm-Ma...var=562295573937&_trksid=p2060353.m1438.l2649
 
Top Bottom