That just happened...
I’m glad they updated the website with better pictures. With renewed confidence I ordered a B1 head and extra coil plus 3 and 4 mm rubies. I’m psyched to get it.
I use the chadbro terp trunk
Honestly, I think that with the tiny controller for the Ti and XL, Herbo is mighty portable too. Love the detachable cord and case that it comes with. Yes, glass can break, but if I am grabbing a heavy hitter to head to a buddy's house with (presuming he/she has glass bubbler) Herbo is the most portable of the bunch. My biggest surprise when I got it.I’m surprised at how small and light the PID is. Same with the actual injector too. The flowerpot is a really great portable setup because it’s tiny, and it’s not made out of fragile glass. Much more portable than say a Herborizer or a vapbong. The flowerpot can slip inside a sock and inside your bag no worries. Or it can be easily dissembled to the point of not clearly being a vaporizer at all.
View attachment 14352
Enjoy, there is a learning curve, and I find that a passthrough adapter works great to give a carb (the 10mm stopper) and to keep the hot parts away from your more expensive glass rig.The Weed Eater arrived Thursday. First time was not good at all. Next attempt I slowed down the draw and
I read at least the last 200 pages of this thread. I watched all the reviews I could find except one annoying lady.
To anyone that is on the fence, it is all they say it is. It will blow you away. A true heavy hitter.
I tried the carb cap again last night. I don't think it matters much. I did a bowl with out cap. When I got no more vapor, I put the cap on and got one more draw of vapor. So it does work. I do understand that when the bowl is under even a slight vacuum the heat disperses better to get to all corners of the area. It also lowers the boiling point of the material, so it will evaporate better. Still up in the air....
As far as using less material, not yet. Too much fun......
With the VROD @ 650, I didn't really heat soak or anything, I'd just place the VROD on the shovelhead and draw softly until there's function and bubbles, then hold that soft, slow draw as long as possible before pulling the VROD off and clearing it.to make things easier first tell how you are doing your hits currently , and the type of hit you are looking for. the more descriptive, speed, length ext the better
Oh, sorry, I meant I don't heat soak the bowl. I heat soak the head unit for sure. I've seen people who place the VROD on the bowl and wait for the temp swing to settle. I always just put it on and start pulling. I'm all for the full volume lung hits, that's how I'm trying to operate here.you will see a tremendous difference if you heat soak for 10 minutes before use. with my e elev8r which I also run at 575 on my Auber, I like to start slow to prime the bowl, then really rip it for a bit (your cheeks should be sucking in), and finally slow down to a comfortable draw to finish my hit. I do big hits, the full volume of my lungs.
The first sentence is where I get confused. Ripping the whole time gets me less char than a slower draw, that's why I was wondering if I was doing something wrong.if you rip it the whole time you run the risk over vaping/charring depending on your temps obviously and other variables.
sometimes I heat soak the shovelhead bowl but not often, can't even remember the last time I tried with the glass bowl. heat soaking the bowl with the baller is even less necessary imo there is so much heat potential from the draw I don't want the extra heat in the bowl.
have fun experimenting my advice is just a guideline and you might find a different technique works better for you, not to mention my experience is with the e elev8r not the baller so your results may vary