Detonator
Well-Known Member
Welp, my Solo just went literally loopy. has this happened to somebody else?
Yes, what is it doing?
Welp, my Solo just went literally loopy. has this happened to somebody else?
Yes, what is it doing?
Fixing a SOLO is a no brainer!@Will B. Good
To manually reset your Solo:
- plug in the Solo unit to charger
- press and hold both buttons for approximately 4 seconds
- wait for 10 seconds then unplug from charger
Welp, my Solo just went literally loopy. has this happened to somebody else?
Well, it was working just fine this morning and after finishing a bowl, I put it to charge and it did fine until half-way. Then it slowly began to loop more and more often, going in intertvals of charging and then going as you see in the video. But it was still able to charge almost the whole battery apparently. If I want to turn it on, it only beeps with the blue light and turns off. If I connect it to the charger it goes into a loop. It is a 2012 Solo and it has seen plenty of use.
Oh don't worry, I had already shot Randy a message and he gave me a good deal on the Air.Old enough to run PA, too bad you don't have one......
I'm still thinking battery (one of the two cells...). Normally they degrade slowly, but sometimes go truly South with no warning. Too bad you don't have another (known good) pack or a PA. Probably time to think about checking the deals on PIU?
Good luck with it.
OF
Well, it was working just fine this morning and after finishing a bowl, I put it to charge and it did fine until half-way. Then it slowly began to loop more and more often, going in intervals of charging and then going as you see in the video. But it was still able to charge almost the whole battery apparently. If I want to turn it on, it only beeps with the blue light and turns off. If I connect it to the charger it goes into a loop. It is a 2012 Solo and it has seen plenty of use.
EDIT: I've been trying to reset with no success.
I feel like that would be a job for the arizertech guys but I don't know if they'll take in an old model unless its for refurbishing purposes. For now, it seems to be working back to normal. I just vaped one bowl and it's charging. Maybe it was feeling down today(?) .that is what mine was doing also... I ended up fixing it, if you look back a page in this thread I talk about it. But it depends which model you have
the older model has 2 wires going to the bottom of the oven, and 2 wires going to a white lump on the side of the oven that can't be removed... and I couldn't fix it..
but my newer model with the 4 wires going to the bottom of the oven was fixxed when this area was cleaned out.. Not too difficult to do, it actually just involves taking out a few screws... and cleaning some residue under the oven..
mine is no longer under warranty so I didn't mind taking it apart.. and I just had a feeling I could fix it..
It's just a 1.000 meters high hikingHow 'high' did you get on that fabulous looking mountain
This exact same thing is happening to mine, the charge light will briefly turn red then go yellow in the loop. Does anyone know what the fix for this is? I have an M1C1 and was able to use my PA to charge my unit and power the vape to use when the battery was dead.Welp, my Solo just went literally loopy. has this happened to somebody else?
Welcome to the SOLO thread, Its all getting very International in here.Hey folks
I'm new to this forum and I want to say hi. I'm Tomy, I live in Vienna, Austria and I'm working as an electrical engineer.
If I wanted to get a Pinnacle water tool, where would I find the best price?
I see some on ebay for $36.99.... That seems too good to be true though IMO. VaporNation has them right now (with their 420 20% off sale) for $55.99. They're an FC sponsor and can be trusted, so IMO that's probably the way to go.If I wanted to get a Pinnacle water tool, where would I find the best price?
Welp, my Solo just went literally loopy. has this happened to somebody else?
Hey folks
Greets to all of you and happy vaping,
Tomy