Glass Vapes From The Rogue Wax Works

nicknobody

Well-Known Member
@coolbreeze glad you are enjoying that piece. Its really nice!!

@Flotsam best technique is medium grind, no pack, preheat bowl, then heater. I dont use the screen and just have an ash catcher for the stuff that falls through. The key is to keep good airflow for full, even extraction

@El Duderino I just listed them again

Drop, Thursday 3/20 @ 6PM PST. Vapor Pipes, TM Stems, LOBO/ONE Stems, the Vapcap "Roach" and the QR Baller will be in stock in limited numbers

https://www.reddit.com/r/TheRogueWaxWorks/comments/1jfhda1
Hopefully you will post some of the coil handles that you teased for the previous drop? If not I’ll send you an email?
 

friedrich

Little-Known Member
the QR Baller
I was growing interested in getting one of these until I just now realized that it has an 18mm joint! Have you considered doing a 14mm baller? I imagine it might be too narrow and air-restrictive if just scaled down, so I'm picturing a design like the Megacicle..

While I'm at it, would you consider offering with sapphire blue corundum balls? Kind of silly, I know, but it would be nice to match my HMK piece! :lol:
 

olysh pops

Well-Known Member

RogueGuy

Well-Known Member
Accessory Maker
It came to my attention that some of the QR Baller heads were too tight in the coils. I unwrapped all the Ballers and measured and passed them through an average coil and found roughly 60% were too large. The issue is that there is a slight bulge on the end with the holes.

If you are using it wired, this should present no issue. The open end fits fine, and it is being held in with the two clips.

If you are using it wireless, you cant use it the way that I have shown in videos. With the handle at the open end, dropped into the coil top down. But you can just run the handle at the top and drop it into the coil, open end first. I have been running this setup today and not finding any difference in extraction. I figure the heat rising through it is keeping it at temp.

If you have one of the tight ones, email me at theroguewaxworks@gmail.com so we can figure out the best solution for you.

Sorry about the inconvenience and frustration if you received a QR Baller and were not able to use it as you had intended. Please be assured that your specific situation will be remedied but that I will be more diligent about doing more through QC prior to sending things out

https://www.reddit.com/r/TheRogueWaxWorks/comments/1jnn02w
 
Top Bottom