For those Canadians who sent their Crafty in for warranty, how long was the turn around? Also did you have to send to the US or Germany? Any trouble sending a device that may still get caught by the drug dog going through customs? I've had mine since February and it gets daily use, put a ton of hours on it, way over a hundred I'm sure, but lately starting to see a lot of issues:
- Overheating quicker even at low temps like 180C
- Getting the flashing red led when turning on. Only way to get rid of it is to do a factory reset by holding the power button for 30sec.
- The plastic lip the cooling unit screws into are breaking off among other plastic pieces. Must be do to the heat and plastic getting brittle. I baby this thing and it has never dropped.
- Still need to get updated firmware so it works with KitKat
- The whole unit feels like it gets hotter than it usually did.
Despite all that it is still works enough but it must be on its last legs and would like to get it replaced.
- Overheating quicker even at low temps like 180C
- Getting the flashing red led when turning on. Only way to get rid of it is to do a factory reset by holding the power button for 30sec.
- The plastic lip the cooling unit screws into are breaking off among other plastic pieces. Must be do to the heat and plastic getting brittle. I baby this thing and it has never dropped.
- Still need to get updated firmware so it works with KitKat
- The whole unit feels like it gets hotter than it usually did.
Despite all that it is still works enough but it must be on its last legs and would like to get it replaced.