kindbeats
Terps Up, Temps Down
Hey G, I'm a little confused about the super stealth kit. Would I be able to run an SR-71 on it at 7.4v or should I just get it for K.I.S.S. carts fired at 3.7v?
Discontinued The Persei Vaporizer for herbs and concentrates.
- Thread starter THC SCIENTIFIC
- Start date
Hey G, I'm a little confused about the super stealth kit. Would I be able to run an SR-71 on it at 7.4v or should I just get it for K.I.S.S. carts fired at 3.7v?
MileHighLife
Blower of glass, grower of grass
kindbeats
Terps Up, Temps Down
Thanks @MileHighLife! That's what I figured. I'm thinking of getting one with a couple of K.I.S.S. carts for when I need to be a little more inconspicuous. I just hate to think of sacrificing the taste that the SR-71 delivers. With the SR-71, I like to load oils that I don't necessarily enjoy on a nail (taste wise) and when I vape them, it brings out terps that weren't present when dabbing off of my nail.
EDIT: Just want to make sure, can the bottom spring/cap of the SS tube be used with my standard tube? I ask because I need to replace a spring in my Persei and figure I may as well just buy the SS kit for both the super stealth option and the bottom spring/cap if does in fact fit my standard tube.
syrupy
Authorized Buyer
I have the SS in front of me. and it looks like the long SS tube is about a half inch shorter than the standard one. The SS bottom will screw on the stock tube indeed, but the battery ends up that much shy of reaching the top.
*missed it by THAT much!
Last edited:
jpdnkstr
Well-Known Member
The long SS tube is for using a single 18650! The short tube is for using a single 18350. Same voltage, just longer battery life from the 18650. I can fit 2 x 18350's in my long SS tube, but it is not recommended because it compresses the spring too much, and defeats the safety feature of the spring. The SS tubes can be configured for lots of different options, just don't do it unless you know what you're doing, kind of thing!
Caligula
Maximus
OF
Well-Known Member
You've got problems. The heater wire is Nichrome (one of several alloys...) so not a huge deal. But if you look close you'll notice the wires coming up from below are slightly larger and welded to the heater wire above the tubes they enter by?
The heater wire is actually 3 pieces of two different types welded together (the center heats, the ends don't). You're not likely to find it, it's the sort of part you need to buy made up custom.....or fuss with a LOT if you have the right gear to do the welds and the materials.
Down the road perhaps UP (or D9 or THC or whatever they are now....) will sell the heaters (perhaps prewound, winding such wire is not trivial), but for now I thing replacement is the only practical option?
OF
Breathemetal
Well-Known Member
I want one so bad....but only w/ the bender.
I have no access to oils right now so it would be a waste of $.
But agh the bender looks so delightful!
I bet the flavor profile is wonderful.
I have no access to oils right now so it would be a waste of $.
But agh the bender looks so delightful!
I bet the flavor profile is wonderful.
syrupy
Authorized Buyer
Is it a standard 18mm fitting?
ataxian
PALE BLUE DOT
I have 2 or 3 of most things for that reason.One lesson that a lot of vaping enthusiasts learn the hard way is that it always pays to have a backup or even better, a backup for your backup.
I need a CORE!
Always something I need!
This is just one drawer!
mystikalghost
Well-Known Member
I have 2 or 3 of most things for that reason.
I need a CORE!
Always something I need!
This is just one drawer!
I'll be there in 20.
ataxian
PALE BLUE DOT
My larger deeper drawer has way more gear.
Bigger vaporizers and glass water pipes.
The W9 TECH stuff fits my set up so well because these devices are fast and easy.
Plus I love concentrates.
Just think?
"G" is creating a DESKtop?
Can't wait to get one of his new inventions!
Normally it's the WIFE with the hand bags and shoes!
Forget that!
Worry about the HUSBAND with VAS and GAS!
The new reality show!
Last edited:
mystikalghost
Well-Known Member
Seriously. I have seen pictures of what happens to people who REALLY get in to e-cigs and mods and RBA's and all that fun stuff. I expect the same here. I want to buy every type of cartridge and 510 attachment there is to find the perfect one
. Once I found out about concentrates I haven't gone back...masterprophet
New Member
With oils in a broken cartridge can I just heat it up and pour it out??
ataxian
PALE BLUE DOT
That's what I do!
masaki
Well-Known Member
Youre all doing it wrong. This is how you use the SS kit:
1x 18350 shorty @ 3.7v & 2x 18650 long tube @7.4v.
Both setups have room for the spring to compress if necessary.
hows your button black on the shorty?
SlinginPaint
As Above ∞ So Below
I would use some pliers or vice grips to hold the cartridge, to keep your fingers from getting too toasty.
bellas
Well-Known Member
Yes 18mm
Caligula
Maximus
Its just the reflection of the keyboard.
masaki
Well-Known Member
oh ok I thought u put a extension on it. it looked good tho lol