OF
Well-Known Member
I accidentally presssed the fill tool too hard down and ended up compressing down the air tube plate thing you see on top . The cart is working fine and giving wayyyy bigger hits than the 2.4 i was using before.
or are those not safe to use while hitting and just for storage?
Bummer. If you pressed the bridge down you probably pushed the tube into the furnace itself. They're stacked up, the only way for the top to go down is for the bottom to do so as well. Hey, if it's working it's working......
No, don't use the white cap. You don't want to seal the tube to the outer tube in use. Pressure can then build up inside the tank area and force all you lovely concentrate to come gushing out all over your shirt pocket at the worst possible time. This has been confirmed experimentally.
oh and you guys might get a kick out of this, the other night i was reachin for my pen after a ti nail session and i mistakenly grabed a brand new 5 ohm cartridge instead of the 2.4 ohm that was full. nothing happend ofcourse and it had a faint taste of metal . i looked to see the 5 ohm marking on the cartridge and face palmed lol. ofcourse even the 3.7 battery dry fired ruined the cart luckily i had some more.
Another bummer. Lucky you spotted it and knew not to throw fifty bucks into the lame cart! That can turn a 'bad break' into a 'man made disaster' in short order.
Good luck with your Persei.
OF