Honestly I was hoping you chimed in on this subject. Is it really worth it? I dont want to buy one then find out I should of waited for the Alpha.
And if I am getting the 6v setup 4ohm or 3 ohm???
Kinda scares me I'm helping a good boy go bad and all, but if I knew what I know (owning one) and didn't have one already, I'd have one on the way.....if that makes any sense? That big old battery makes it go and go and go. Surprisingly (to me) it fits the hand better than you'd think it would, it's not as big as I expected.
I've run 4 Ohmers at six volts before, a serious handful IMO. I'm not a 'big cloud' kinda guy, though. But they're easily twice the 2.4s, at least on par with 1.5s at 3.7 Volts (that's an honest 3.7, not what you got from the original V2). I'd recommend starting on fours, or even fives until you're comfortable, you can easily have it get away from you.
My only negative about it is the button. It's a very nice switch, perhaps the best of it's type I've seen on a vape, but the protective skirt is tall and my fat little thumb has to press straight down to make it go. It's a safety feature, of course, so I'm not calling it short.
I bet you end up with one anyway, and you'll be kicking yourself for the extra forty bucks....which you could use to buy a tasty gram to christen it with....
my persei keeps shutting off like the light goes off after 2 to 3 seconds when my evo 6v top is connected to the 510 connector and plugged into the top both tops are both acting up like this what should i do??
Sounds like a battery issue to me, isn't that the routine for discharged battery? Does the time get shorter each time you do it? Do you have a second battery set? One cell shutting down I think shows up this way. What happens if you try to run it at 3.7 Volts (I know it doesn't get hot enough but does the light stay on)?
OF