I was already considering the grinder, another magazine and 40 caps. It's not much more for that kit with a scale so i might go for it in the new year.
It's nice to see an increase in activity on the S&B Youtube channel in the last few months.
And to see a 'Watch Video' tab on new additions like the filler kit.
They won’t sell me the plunger separately
Hate those geographical exclusions!
Did they sound like they were aware of availability in EU and an exclusion in their zone?
It could be a matter of time.
Could the capsules be used to make the mighty a proper “on demand” vaporizer?
I think about filling a capsule, heat the device up, three puffs, then popping out the capsule (for a later use) while it’s still hot to avoid the prolonged cooking. Anything wrong with the idea?
I tried what you mentioned but the short gap between each puff is probably enough to cook some of that life and taste out for the later uses.
As an experiment to maximize the concept using a capsule, I turned the Mighty upside down and twisted it open to lift the heater part away.
You should have an upside down CU in one hand with the capsule lightly seated in the CU inlet, and the heater in your other hand.
I put the temperature up full and I dropped the heater on, held it there without twisting it shut, and I "heat soaked" for 2 or 3 seconds just to be sure.
Before you're finished the draw you can lift the heater away to cool the load with some air at the end.
Presto you're only really heating the load while drawing.
Just be careful with the hot capsule and familiarize yourself with holding the CU upside down and lifting the heater away without knocking the capsule onto your bare skin!
You could also try putting enough material for 3 puffs in each capsule and using like normal, maybe raising your start temp.
If you want to hold the small loads steady inside there are ways for that.
Enjoy!