I used Herbie last night with my 18mm VXL HT instead of the 14mm WT from VaporBlunt and the difference was huge! The wide open air flow made for a great hit and the half full bowl was spent in three hits, mostly on the first one which was a massive hit. Only Herbie and the Cloud can keep up with a full throttle hit like this, and they go about doing it in such different ways!
Also, I sent an email to support about the bags leaking a little and got this response for all to enjoy:
Hi Stickstones, Josh here. You are correct sir, them balloon don't fit as snugly as designed and 'some' leak just a bit when sitting flat on a table. Both of these issues are being corrected, and you'll see both issues resolved in May. The details are that, the silicone expands when it is released from the manufacturing mold, and the bowl lid outlet shrinks just a bit, and combined they cause a less than optimal seal. Now that these expansion rates are understood the tooling is getting modified by a few thousands of an inch to resolve it! With regard to a bit of leakage when the balloon is filled on and sitting on a table, this happens to perhaps 20% of balloons and the amount of leakage is small. Nonetheless we all want it to be an air-tight valve and it shall be.. design mods are in place for that too! I hope this response satisfactorily answers your questions, and thank you for bringing a design deficiency to our attention.
By the way, the software glitch that people have been talking about is also fixed now. We would not have found it without all the feedback from FC!
You are welcome to share my response on FC if you think it would benefit the community.
Best,
Josh