Repairing a Broken Flowerpot Ball Vape

[maxih4]

Hello guys,


I don't know what to do anymore, so I have to ask you for help and tips.


I have a Flowerpot B0 injection ball vape, and from one day to the next, it just stopped working. The display on the controller turns on, but the nail doesn't heat up anymore. The display only shows the current temperature, no matter what I set with the arrows.


I thought I could repair it myself, so I bought an XMT 7200 PID with a built-in SSR (because that’s what I read from the old PID) from AliExpress. Now I’ve received the new one, wired it, and the error is still the same—the nail doesn’t heat up.


Any ideas on what I can do or what might be wrong? Could the nail be damaged?


I also attached some screenshots of the old and new PID, including the manual and my wiring. Maybe that helps.


New pid:

Old pid:

Thank you all in advance!

 

[Hippie]

It could be the coil so my next step would be to try it with another coil

 

[maxih4]

It could be the coil so my next step would be to try it with another coil

Is there any fitting coil from aliexpress that youc an recommend? or what do I exactly need to buy?

 

[Hippie]

There's lots of cheap ones on ali
I got one delivered for less than £20

You don't need to worry about the rotation of the coil for the b0
You just need to check to make sure it's wired correctly for newvape/cannabis hardware/auber/disorderly conduct/710 coils ... ( Pin 1 is AC live line, pin 2 is AC zero line, pin 3 is temp positive, then 4 is temp negative and pin 5 is ground )