Mrs Gorilla says always let your hot balls cool off before handling them. And to stop touching them all the time.
Of course, I never listen,sooo....
I made this awhile ago to see if a glass pathway tasted any different/less harsh on my throat with prolonged use compared to a ceroma and a herborizer ti.
The adaptor im using has thinner glass than the QShop ones(cheaper too incase it goes wrong), I
believe this helps it not shatter over time as the coil fits a little better, less pressure from the coil on the glass, and possibly thinner glass
may have less internal stresses through repeated heating cycles,Dont know.
It does offer a cost effective glass path,
HOWEVER -
Unless you already have a PID Controller,heater coil and Ruby/Glass or other Balls (I do not suggest You use the fleshy kind)
, it will only save the cost of the injector body. Minus the price of a cheap ali ex. glass screened injector bowl.
The coil is not tight on the glass, snug enough to transfere heat, it grips on the nubbin left by the glass handle. The heater coil can get RED HOT while its getting up to temperature. Scary to watch, but the temp change isnt too fast for the glass so far but ..........It
could explode sending glass and rubies everywhere,but I think its more likely to just crack. I hope. I believe some luck with the individual bowl you get having no internal stress or defect is also needed.
That said....
I have used it for over 6 months,with almost 1000 hours running at between 425f and 455f. Tastes as good as the Qaroma. Works/handles more like the Herborizer . Just as heavy hitting as either. Downsides (apart from possible exploding hot glass balls) it can have slightly bigger temperature fluctuations. It has a smaller hot spot than the qaroma, so needs a little more stirring and attention to breath/airflow control. Or just piling your green in the centre of the screen leaving a gap round the outside. Works best with sub 0.1 doses.
Will work with crumbs.
I turn it on and it stays on for the day, I have left it running for over 24 hours, have dropped it on my desk, a had a water pipe tip over with it in (It and the pipe were fine,the injector bowl it was in broke ) No signs of the glass cracking, yet.
Even the built in glass screen still has NO cracks between the holes. I do use it over a desk tho'.... dont think i would sit back in a sofa with it. Just incase. But thats true of any of my other heavy hitters.
I used to heat it in 2 stages for the first month, to 200f first, then to 425f, but just run it straight up to temp now.
You can wreck the coil and/or the glass while fitting the coil. Be patient. Have 2 sets of pliers on hand. Dont stetch the coil till you need to. Go slow. I fed it over the bulge from the bottom and kind of screwed it on. Be very careful if you need to 'open' the coil wider to increase internal diameter.
Be aware that stretching it out will reduce the internal diameter slightly.
Do you have a problem with your balls dropping?
Do your balls keep slipping out while handling them?
Hold on to Your Balls ! With the Ruby Restraining Titanium Terp Pearl Top Trap Wire Clip. Thingy.
The titanium wire clip thingy takes a while to make and get tensioned right. You have to work harden it after you form it.
Stainless Steel will work but is not Ideal, Titanium has more springback, is 40% stonger and is generaly considered hypoallergenic.
aND Looks Prettier when you anodise it. like me, its pretty basic.
The next iteration is a little different.
If you try to make your own, REMEMBER TO THOUROUGHLY CHECK YOUR BALLS. WONT FALL OUT WHILST IN USE.
Investigate lavender oil for minor burns. Works well after cold running water for at least 5 minutes depending on severity. You have to stop the fat cooking under your skin........ Dont take my word for it. Look it up. And dont use butter on burns.
I know this from other experiences. My hot balls have yet to fall. Dropped many,many cold ones tho'.
Also remember, picking lots of small balls up off the floor everyday is good excercise for knees, hips, fingers and for learning patience with oneself in the face of repeating our own futile behaviours..... Unless you got arthritis. Then its a pain in the balls.And everywhere else.
Must. Make. Paper funnels...paper funnels..paner funpels...faper punnels...paper funnels...
The joy of an industrial hot runner and PID as standard kit for Vapourists. Respect to the injector head baller vape and all who have put their thought and time into it, allowing us the best of medicinal use combined with the ability to get truly trashed.
