Can you guess what it is yet?
Yep I am pouring more money down the drain. This is the start of mark 2.
The idea behind this is simple. Make some kinda adapter so a splinter Z can be in a side by side config, rather than on top. End result something pocketable.
Mark 1 failed. It worked but was too big for your pocket. Mark 2 is gonna be based on the P80 rather than the 2 battery somant and have no wood frame. This is just the adapter. Was toying with the idea of opening up the mod and have wires coming out - but I got scared!
Parts used so far
1x Loop RDA - £10
Some 16 awg wire - £3
Source 510 30mm vflat - £10
10p coin - 10p
Glue
Source V3 M10 510 Connector. The best 510 connector, featuring 7KG + force pre-tensioned wave spring, PEI Insulators & more.
www.stealthvape.co.uk
So I have taken the RDA sleeve and cut the top off with a hack saw. Then cut down by one of the Air ports to form a groove for the cable. Removed the grub screws and soldered the cables straight on the RDA. As this RDA has 4 holes, for 2 coils I have used 4 cables. 4 cables means less resistance. Some hot glue from the glue gun and some epoxy. A 10p coin on top.
I was going to use some heat shrink but I might just leave the cables as they are. This silicone wire is quite flexible and the heatshrink a lot less so.
Waiting for this to dry then I am going to cut the cables down and solder on the 510 female. Not sure what I wil do at the 510 female end? Leave the contacts bear or cover somehow?
I could find a small plastic container to cover or mould some epoxy putty round the contact? Anyone else got any ideas?
Splinter Z will be held to the mod with bands, again open to ideas here?
Lets hope this works and I am not just waiting money again. Hahaha.