DIY Enail Project

[Puddy]

Has anyone here had any experience building their own enail/temperature contoller box? I was bored and looking for a new project to do and found a few cool reddit articles so I'm going to try and make my own. Was able to buy an Omron PID temperature controller on ebay for super cheap, and rest of the pieces just on amazon. Now the wiring is where I'll run into issues probably but I'll try and keep this thread up to date.

https://www.reddit.com/r/CannabisExtracts/comments/1kczbg/diy_enail_howto/

 

[Abysmal Vapor]

I was looking into these DIY e-nails, there are few good threads,i also found most of the parts locally, sadly i till have to order a coil + nails from China, and when i do the math, it is not much cheaper than a full kit from DHL(97$)
Do you know if those OMRON PIDs are any better than those used in the Chinese ?

 

[Puddy]

I think the Omron's are supposed to be some of the better ones on the market, but cannot say from any experience, just from word of mouth. I know they use this same model in these:
https://highfivevape.com/high-five-lcd-1-enail.html


Here is the one I ordered off ebay
https://www.ebay.com/itm/162180387310