Arizer Solo

OF

Well-Known Member
approximately how many stems do you guys get off of a full charge?

I run 8 or so sessions (mostly at step 4) between charges. There's usually an LED or two 'still left' but I try to avoid deeper discharges in favor of longer battery life span. I also stop charging before the charge LED stops flashing (but with the top LED lit) for the same reason. Running at step 7 increases consumption about 25% so I'd expect 6 or 7 sessions to 'out of LEDs'?

OF
 

Gray Area

Well-Known Member
I run the solo on high temps (5, 6 and 7 only really)., and would say that about one session per led is about right.

Five sessions throughout the day and I'm usually down to two led's battery by the time I get home (and the PA comes out).
 

Thevaped1

Active Member
Just got my solo and yes it's a great device. I wanted to ask you guys for some guidance. The model I got was the m1c1 and it does heat up kinda fast. The first time I used it it took 30 sec to heat up to 7. After that it takes about 1 min to a min 10 to heat up to seven. Isn't that kinda fast to heat to 7. I though the solo needed at least 1:35 to reach level 7. What do you guys think are all m1c1 the same?
 
Thevaped1,
  • Like
Reactions: Snappo

cawshook

Solod out.
I've never done decarbing or winterizing , maybe somebody else
can chime in .

here's the link for the mouthpieces ,
I highly recommend getting some to help relieve any inhale
restrictions .
e-Cigarette tester "condoms" - package of 5

Yes it can , slightly more tasty too .
All the trichs and terps are in tact .
You'll have to flip the nug tho for even roasting .



Yes it would ,
It can be better , depending on the size/type of the bubbler .
If you haven't tried water vaping , do it , you'll like it .
I started with a small DIY with the help of O-rings , then got
bigger . And now I'm looking at getting the Cloud .

Also re ; Flavor/taste
I find Sativas offer the most varieties of differing taste .
Indicas Kush usually tastes the same Kushy flavor , which I love .
Add a dab of oil into the mix ...
Then im probably going to try to find a cheap bubbler. I cant buy the water tube right now, so im looking for a cheaper alternative. Any tips on where to get cheap bubblers online and what adapters to use?
I found a hemp shop that has a hoss mini straight tube for 70$.
 
Last edited:
cawshook,

max

Out to lunch
Just got my solo and yes it's a great device. I wanted to ask you guys for some guidance. The model I got was the m1c1 and it does heat up kinda fast. The first time I used it it took 30 sec to heat up to 7. After that it takes about 1 min to a min 10 to heat up to seven. Isn't that kinda fast to heat to 7. I though the solo needed at least 1:35 to reach level 7. What do you guys think are all m1c1 the same?
That's not a model number. It's a 'lot' number. If you bought one that's been sitting on a seller's shelf for 6 months it shouldn't perform any differently.
 

Thevaped1

Active Member
Ok lot number. There have been people on here that were saying that their m1c1 solos were not heating up properly and mine heated up like in 30 secs the first time. After that it took 1 min to heat up to level 7. Now what I was trying to figure out it is "why" is my unit and other people's m1c1's doing that? It's my understanding that it should take 1:35 at least so have people on here figured out why that is?
 
Thevaped1,

ataxian

PALE BLUE DOT
And ya, family's been kama'aina long time. Way before the 808 was a state. Lived in Honolulu and Manoa among other places myself.
I was a NORTH SHORE surf bum during the 70's early 80's.
We had colas as big or bigger than your legs.
The trim was use like saw dust.
It kept the mud off our surf slippers during rainy season.
My parents lived in KAILUA.
Too bad we did not have SOLO's at the time.
Pack a week of ZIG-ZAGS.

In Hawaii we only smoked top colas.
The rest (sugar trim, small nuggets) we dropped on the ground.
Leaf was to send back to the mainlanders!

Starting to talk story!
 
Last edited:

rebelxd

Well-Known Member
Received my Solo last night, sooo happy with it. Very effective.
Im pretty happy with the standard stem, not even sure if I need to try the efficient stems? is it just a smaller bowl/chamber?
 
rebelxd,
  • Like
Reactions: ataxian

Dreamerr

Always in a state of confusion and silliness♀
Ok lot number. There have been people on here that were saying that their m1c1 solos were not heating up properly and mine heated up like in 30 secs the first time. After that it took 1 min to heat up to level 7. Now what I was trying to figure out it is "why" is my unit and other people's m1c1's doing that? It's my understanding that it should take 1:35 at least so have people on here figured out why that is?

Nobody reported back with answers from arizer except that they said it was normal. OF posted, if I get it correct, that the lights might not be accurate and I will add on that LOT number. One of the posters with the C lot said he was sending it back but we have heard nothing that I recall since then.
 
Dreamerr,
  • Like
Reactions: Seren

Caligula

Maximus
Do the air holes at the bottom of the heating Chamber ever get clogged and/or need cleaning? And if so how do you go about doing that?
 
Caligula,

OF

Well-Known Member
Do the air holes at the bottom of the heating Chamber ever get clogged and/or need cleaning? And if so how do you go about doing that?

I've never had an issue, there's not much flow really. I bet you could easily blow it out from the top if it really became a problem. If not it's easy enough to remove the four screws and get to the other side (but IMO not necessary). Be careful not to tighten the screws too much, guys have cracked the holes out.

The main function of the holes is probably to ensure a vent path should the battery decide to make a fuss.

OF
 

abhishek

Well-Known Member
Do the air holes at the bottom of the heating Chamber ever get clogged and/or need cleaning? And if so how do you go about doing that?

I use a broken match stick, to lightly brush the holes..and then I suck all the air from chamber...yeah it doesn't sound that nice, but I jus love my solo so much that I agree to suck it down..
 
abhishek,
  • Like
Reactions: Caligula

Dreamerr

Always in a state of confusion and silliness♀
I use a straw to suck up anything loose almost every session. My cut up little straw is my fav tool along with my ssv pick which I can just stick the end in the whole if something is caught. I then turn it over with cap off and shake out bits and pieces. Since I have been using the straw I don't get bits and pieces anymore. I also use the straw to clean the stem so I get some nice bits to eat.
 
Dreamerr,
  • Like
Reactions: Snappo

ataxian

PALE BLUE DOT
Just sent my solo back in for warranty replacement. Already missing it :cry:
I tried to send one of mine back however ARIZER acted as if I was some stupid low life?
So I fixed it myself.
Now I have two.
Pretty cool you actually get a replacement.
I love these devices however not so keen on ARIZER.

If I ever need another one I will most likely buy it direct from PLANET VAPES!
 

exit

Well-Known Member
I tried to send one of mine back however ARIZER acted as if I was some stupid low life?
So I fixed it myself.
Now I have two.
Pretty cool you actually get a replacement.
I love these devices however not so keen on ARIZER.

If I ever need another one I will most likely buy it direct from PLANET VAPES!

Did they know who they were talking to?????!!?!
I trust you informed them THE GREAT ATAXIAN was the owner of that Solo?

I bought mine from PUFF IT UP (randy owns!) so I am getting my replacement done thru them.
I only dropped it in the mailbox today but I assume it will be easier going thru PUFF IT UP than ARIZER directly?

Honestly with the VXC CLOUD in the mix I only see myself using my SOLO away from home ;)





I see you bought a LSV! Cool stuff I might pick one up at the end of this month! Been wanting one for a while!
 

Thevaped1

Active Member
6ButuBm.jpg

Have any of you guys received a solo that looks like this? This is how I got mine and I thought the bowl was dirty so I tried cleaning it with iso and nothing. It looks like the specks are part of the stainless steel. Have any of you received a solo that looks like this?
 
Last edited:

ataxian

PALE BLUE DOT
Did they know who they were talking to?????!!?!
I trust you informed them THE GREAT ATAXIAN was the owner of that Solo?

I bought mine from PUFF IT UP (randy owns!) so I am getting my replacement done thru them.
I only dropped it in the mailbox today but I assume it will be easier going thru PUFF IT UP than ARIZER directly?

Honestly with the VXC CLOUD in the mix I only see myself using my SOLO away from home ;)





I see you bought a LSV! Cool stuff I might pick one up at the end of this month! Been wanting one for a while!
I don't have a BIG TEXAS BELT BUCKET or the budget for a $500 vaporizer! (LOL!)
So I bought a dirt cheap LSV for my water setups.
Monday or Tuesday I will be well medicated.
I say that however my SOLO is doing a good job as I write!
Water Path setups I have however between My PHVES and STOCK STEMS DRY I rarely break out water these days!

I bought the LSV for WATER WORLD!

I was going to get a CLOUD as well however I bought some other gadgets.
attachment

Have any of you guys received a solo that looks like this? This is how I got mine and I thought the bowl was dirty so I tried cleaning it with iso and nothing. It looks like the specks are part of the stainless steel. Have any of you received a solo that looks like this?

Attach a stainless steel small brush to a drill chuck and manually clean it.
Or just pull out the weapons:
Here's a cheap low income HARBOR FREIGHT UNIT!
 
Last edited:

Caligula

Maximus
Did they know who they were talking to?????!!?!
I trust you informed them THE GREAT ATAXIAN was the owner of that Solo?

I bought mine from PUFF IT UP (randy owns!) so I am getting my replacement done thru them.
I only dropped it in the mailbox today but I assume it will be easier going thru PUFF IT UP than ARIZER directly?

Honestly with the VXC CLOUD in the mix I only see myself using my SOLO away from home ;)





I see you bought a LSV! Cool stuff I might pick one up at the end of this month! Been wanting one for a while!
Hope it goes well. This will be my path if my solo every died.
 

exit

Well-Known Member
approximately how many stems do you guys get off of a full charge?

I used to get 7-8 without needing to worry.
Now I only get 3.
That is why i sent mine back on warranty!
7-8 is what you should be getting on a full charge.

In other news you guys have FINALLY converted me!
OR well maybe my VAPEXHALE CLOUD has convinced me!
Heat level 6 is too much of a FLAVOR COMPROMISE!
I only run my SOLO at heat 4 now!
 

Quetzalcoatl

DEADY GUERRERO/DIRT COBAIN/GEORGE KUSH
attachment

Have any of you guys received a solo that looks like this? This is how I got mine and I thought the bowl was dirty so I tried cleaning it with iso and nothing. It looks like the specks are part of the stainless steel. Have any of you received a solo that looks like this?
cant see pic... download, upload to imgur.com, copy the BBC code part, and paste into reply box here.
 

Thevaped1

Active Member
I don't have a BIG TEXAS BELT BUCKET or the budget for a $500 vaporizer! (LOL!)
So I bought a dirt cheap LSV for my water setups.
Monday or Tuesday I will be well medicated.
I say that however my SOLO is doing a good job as I write!
Water Path setups I have however between My PHVES and STOCK STEMS DRY I rarely break out water these days!

I bought the LSV for WATER WORLD!

I was going to get a CLOUD as well however I bought some other gadgets.


Attach a stainless steel small brush to a drill chuck and manually clean it.
Or just pull out the weapons:
Here's a cheap low income HARBOR FREIGHT UNIT!
Oh so is that normal? Shouldn't the bowl be clean in the first place? I can purchase that little drill but just wanted to see if other people were having similar issues.
 
Top Bottom